For the love of God, why the background music?

@Likeaudio

Жыл бұрын

Oh man it's groovy

Tightening it after you bump it in requires spinning the chuck again to see if the chuck jaws threw it back out of center when you tightened them.. indicating is the “last” thing you do

@earnestpeeplesjr8948

6 ай бұрын

Bumping a piece requires a rotating chuck. You can see where its off and better center said piece. Plus a 4(+) Jaw Chuck works better, more precise. But, for a Quick Non-esential job.....this works

Definitely needed this crash course thank you!

The best way is bolt a brass rod in the tool post and run it against the work piece. Works everytime.

Damn , this dude slammed the living hell out that magnetic arm 😂

I found out you could also tap the work piece by the far left end if it wobbles at that point since you are only centering the work where the dial touches so in theory it is only concentric at the indicated point .

I have 2 dial indicators and cant remove the original contact point to place an extension. Im worried ill use to much force and break it. Can you help me figure it out, please?

To save clearing all the chips off the lathe so they don't get stuck to a magnetic base, try this simple method - kzread.info/dash/bejne/nX9q17imiJydmbQ.html

Need to lose the music

Dial indicators are sensitive instruments and should be protected from such blows/impacts. I were taught to at least lift the pointer off the workpiece before striking it.

@mafosa8519

Жыл бұрын

That’s right! I use two bearings attached to the tool post. Slowly spin material and slowly walk in the cross slide up against the material and watch the material 0 out! “ no impact needed!’

@ramennaidoo162

Жыл бұрын

@@mafosa8519That also works great

Very clear bro I think you only makes video you don't work really good lack

Disturb music