Not getting blades to line up properly using the armature spring screw adjustment...help needed

@TheTerrancejayy hey, if I understand correctly you're asking if you can use Outliner II blade set on a T-Outiner body? If so, Yes you can! Would you like me to make a "how to switch Blades sets"?

@delace1111 YES THAT WOULD BE PERFECT. THANKS!

@TheTerrancejayy The new video has been uploaded, checc it out.

@Delace1111 I have a pair of andis outliners i accidently bought an t liner blade and they wont take it back do you think it will work with the regular t liners

Thanks for asking the question, The spring screw is dual purpose part, 1. To apply pressuse to the cutting blade and 2. To position cutting blade Horizontal. If your comb blade(non-moving blade) is screwed on the machine to the extreme left or right it may make adjusting the blades difficult. Start over again from the beginning, Good luck.

Thanks for the comment. Please check my channel for "how to adjust blade set" video, many youtubers found it very helpful. All comments and suggestions, good or bad are appreciated. Also, please rate good or bad so I can get an idea of what you all would like to see more of.

You never explained the correct way too put it.DISLIKE

@thebestchannel5456

7 жыл бұрын

ikr ignorance at its finest i dont get it