Jefferson wraps up the 5.3L LM7 build with new head bolts, valvetrain, valley cover, intake, and valve covers. We are used following parts:
Mr. Gasket SS Valley cover bolts 60920G $33
Mr. Gasket LS Gasket Set 61001G $470
Accel Ceramic plug wires 9004C $165
MSD Coils 826583 $589
Earl’s Head Bolt kit HBS-001ERL $180
Holley Throttle bracket 20-154 $25
Holley valve covers 241-112 $282
Holley Sniper 102mm TB 860002-1 $240
Holley Ultra-Low Ram 300-621 $885
Holley 36lb/hr. Injectors 522-368 $510
All of this is available from ‪@HolleyPerformance‬
Let us know what you think! Have a question? Drop it in the comments, Jefferson tries to answer every comment personally.
Side note- Yes, Jefferson used a 1/4"-drive impact on most of the small fasteners. This gun yield 12ish lb-ft of torque, and it has been used daily for over 10 years, Jefferson knows what it is going to put out, so this one falls into the catagory of "knowing your tools and processes" over buying a specialty inch-lbs torque wrench. Most of us just doing these low-torque fasteners by hand anyway. Just sayin'.