Nice work, key is to take it in small steps. Plus that KECO system works.

@dannyhacker3797

3 жыл бұрын

100% 👊🏻

Nice job Dan

@dannyhacker3797

3 жыл бұрын

Thanks DZ!

Great information. Maybe a little lower on music volume.

Ditch the music

Well explained,even to a layman..🤗

@dannyhacker3797

3 жыл бұрын

Thanks Victor!

Why didn't you start with a Suction cup Most would have popped out Then use a tap down for crowns And PDR gule tabs for the rest The clean up would have been a quarter of the time ?

86° is the perfect panel temp? I've seen others heat to 120°. Which would you consider correct and why?

@collisionglue2564

3 жыл бұрын

Scott, If your seriously interested in learning this process we would love an opportunity to educate you on our theology.

@MegaManDrum

3 жыл бұрын

@@collisionglue2564 Great!

@dannyhacker3797

3 жыл бұрын

You can heat to 120 degrees to remove all the humidity out of the panel but a good pulling range is between 75-85 degrees.

@KECOBodyRepairProducts

3 жыл бұрын

Thanks for watching, Scott!

Disappointed you didn't finish the dent. 🤔

@johnpauly997

2 жыл бұрын

Seems like they never finish…maybe you can’t by just using glue pull

@dmc8103

2 жыл бұрын

You definitely can finish with glue pulling. He's a great tech and I'm sure he can finish. I just wanted to see it. 👀

@LSXMILLER

Жыл бұрын

Lol because the finish was gonna take to long he started wrong from the beginning ? 🤣

This is all, and good, but the equipment you’re using costs thousands. If I’m a DIY guy, and have a smaller dent, it’s still gonna cost hundreds, to get the proper equipment I need? Hence the question? Should I just go to a professional, or buy the mini robo, tabs, glue, and watch all the videos I can about PDR?

@KECOBodyRepairProducts

Жыл бұрын

PDR is an incredibly difficult skill to master no matter what toolset you have. Mastery of PDR often always requires a lot of training and multiple years of practice. We always recommend taking your car to a professional.