Why my ht08A reciever can't bind to ht-8Atransmeter?? but I follow the instructions how to bind I need the as soon as possible or I can put this problem on soscial media...

@HotRC-Sophy

2 ай бұрын

Please forgive us for not being able to log into KZread a while ago, so we haven’t seen your question. Note: 1. The power supply of the receiver should not exceed 9v; 2. The distance should not be too close, otherwise signal blocking will occur; 3. Is the antenna of the receiver damaged?

On which channel to connect an ESC to the receiver?

@HotRC-Sophy

2 ай бұрын

The ESC can be connected to every port of the receiver at will. There is no fixed requirement for this.

Please can you share the instruction manual with me? because I bought that control and the manual did not arrive

@HotRC-Sophy

2 ай бұрын

Of course, please enter your email address

hi do you have a range test?

@DigitalCruzer

5 ай бұрын

I have one on a budget quadcopter, its solid at 100 meters, I've flown it around my house many times low to the ground with my body and house between them with no issue, it couldn't make it around my local school like my ELRS zorro does, but my old flysky and frsky couldn't do that either and I'd say this is basically the same performance. i have had a fail safe around 120 meters but when that happened i may have had my body partially blocking cuz i forgot i had turned facing the other way and it was in a very noisy environment with tones of WiFi everywhere, i have flown it about 1km and back without incident, but i was sure to hold the radio up with clear direct line of sight. The biggest problem is i have found no way of displaying any kind of signal strength or telemetry in betaflight osd to know when signal is getting low, and it doesn't beep or anything to tell you signal is low, only way to find out how far it goes is fly till it just drops and then go find it. My recommendation is use a lower powered vtx so you will loss video first, lol. It's a great line of sight radio though for $28 with receiver. Mine was sbus. But it will need the gimbals lubricated and adjusted, they felt terrible the way i got it, but feels pretty good now.

an alarm sounds at start-up

What channel can i put the power supply for reciever ?

@HotRC-Sophy

Ай бұрын

You can connect any power channel you want, each channel is available

@user-kv8lb9xx4w

Ай бұрын

@@HotRC-Sophy thank you for your fast reply ⚡

@user-kv8lb9xx4w

Ай бұрын

I have trouble binding with the receiver . Transmitter is just flashing quickly with green light . I followed the steps of the manual for code matching . What do I do. ?

@HotRC-Sophy

Ай бұрын

@@user-kv8lb9xx4w Be careful not to place the remote control and receiver too close to avoid blocking the signal if it is too close.

@user-kv8lb9xx4w

Ай бұрын

@@HotRC-Sophy it is still not working

I will take this problem on soscial media if your company did not responds....!!!!