Honwave T35 AE3 inflatable boat setting up on Extreme inflatable boat trailer
Ойындар
Here is us setting up the Honwave T35 AE3 on an Extreme inflatable boat trailer. This is an excellent boat to keep set up but in our view because it is quite heavy and how very difficult the floor is to get in we think for a daily set up the T38 ie3 is a far better boat to buy and is much lighter at 48 kg over 73 kg.
Пікірлер: 17
Hi, thanks for the video. I have a problem with water intrusion with this model. Water appears even on flat days so it's not coming in over the tubes or transom. When accelerating and the bow of the boat starts to lift, all the water suddenly appears at the back of the boat. There are no signs of any damage, the boat is brand new. I had the same problem with the T38 and my dealer took the boat back under guarantee and marking the boat as "faulty". Now it's happening again with the T35 alu and the dealer doesn't believe that there can be the same problem again on a brand new boat so I'm stuck. Any advice? Thanks
@boatingsibbingandwandering3262
16 күн бұрын
Not sure I can help much on this. You will always have a bit of water in the boat that will indeed go to the back when you accelerate. I assume you are putting the bung in the boat the correct way ie from the rear
It gets much easier after a couple of times, you get better and the boat stretches a little. Getting the rear floor central is critical. I have a t40 and install the floor with hardly any air in at all.About 20 mins for full setup
@boatingsibbingandwandering3262
Жыл бұрын
That is very quick. We tried with very little air but found the tubes just kept flopping forwards and made it even harder to get the floor in. I was thinking of a T40 for the trailer but went for the T35 as it is quite a bit lighter if me and her indoors ever have to lift it
@attonicuc44
Жыл бұрын
@@boatingsibbingandwandering3262 also my lawn is not flat, the first time I assembled it on a flat surface it was much easier
@boatingsibbingandwandering3262
Жыл бұрын
@@attonicuc44When will you ever be lucky enough to set up on a flat surface in ideal conditions 😳
The side stringers are wrong there
What size countersink did you use when you reversed the lifting eyes..?
You’ll get the floor in a lot easier with less air in the tubes. Only half fill them.
@boatingsibbingandwandering3262
Жыл бұрын
See reply below to Paul Rush
THIS FLOOR SORTED 3 MIN JOOB
What is a weight of alu floor?
@boatingsibbingandwandering3262
Ай бұрын
Sorry don’t know that but I would estimate the Ali floor alone is 10kg
6:36 much to much air . it must be airless.
Putting the floor in really isn't difficult. You have put far to much air in tubes before fitting floor. Half full at most. Tubes should barely hold shape and still be a bit floppy.
@boatingsibbingandwandering3262
Жыл бұрын
We did let a lot of the air out and the tubes were quite floppy at that point. We Still found it incredibly difficult in that regard
😂😂🤣🤣😂😂🤣🤣💸💸💸💸💸💸