No video
Honda Talon Steering Rack & front diff seal install! JSPORTSXS Tie Rod kit
Alignment video
• Honda Talon UTV SxS ho...
JSPORTSXS Steering rack
jsportsxs.com/...
JSPORTSXS Tie rod kit
jsportsxs.com/...
Alignment video
• Honda Talon UTV SxS ho...
JSPORTSXS Steering rack
jsportsxs.com/...
JSPORTSXS Tie rod kit
jsportsxs.com/...
Пікірлер: 15
Think I will change my steering rack with the Jsport unit looks like fairly easy mod to do thank you good video
@gravesru
2 жыл бұрын
I’m very happy with the rack. Just make sure you loctite the inner tie rod to the steering rack when you assemble.
Hello Russell, you mention that it changes the ratio so less turning the steering wheel for the same amount of turn sharpness, but reading online it says same ratio as stock? I would like a better ratio than stock so appreciate you input👍
@gravesru
3 жыл бұрын
Hi, I was misinformed at the time I made the video. Ratio is the same as stock.
Nice job
Honda talon 1000r steering defect on certain 2021sxs 1000 models . Problem defect in steering system that could cause loss of control Honda sent out safety recalls in NOVEMBER 2021
@gravesru
2 жыл бұрын
Most steering rack issues are from people running the wrong offsets on the front wheels. 5+1 or 6+1 only. Too many people run 4+3 up front. Ruins tie rods, ball joints and steering racks. Then they’re mad at Honda.
Hello Russell, I've just installed the rb3 rack, 1.5:1 ratio rack and it's awesome! Since the install the i4wd dash warning light is on, any ideas what I've done wrong?
@gravesru
2 жыл бұрын
My first guess would be the speed sensor on the front differential, drivers side. Either it’s unplugged or the wires got stretched when sliding the front diff forward.
Good job buddy! Does this rack cure the weak power steering problems of the OE rack?
@gravesru
3 жыл бұрын
Hi!!! I don’t have enough miles on it to confirm that! I haven’t had any issues so far though!
Russell did you have to re-adjust the steering wheel at all? Nice video thanks!
@gravesru
3 жыл бұрын
Yes, I did!!
2 hour job!!!! Lol impossible to do this in 2 hours
@gravesru
Жыл бұрын
You can do it in 90min with power tools! Lol