Just upgraded to fic 750cc for my alll motor nitrous build. Wiring the injector clips in myself so this should help

@thestateofreal2533

3 жыл бұрын

Awesome! Yea I had to do the same thing because I’m using ev8 ID1300 injectors and I had to wire in LS3 pig tails.

I have a question, I have a 97 prelude and I bought it as my first project car hoping to get into cars. It was a crank no start. I found out that my injectors weren’t firing and bought new one but they don’t fire either.

@ssj_sanguine4087

Жыл бұрын

I’ve scrolled on yt and can’t seem to find answers. When I crank the car and pull the fuel rail and injectors out they don’t spray one of the pops out and the fuel spills out. What should I do?

@thestateofreal2533

Жыл бұрын

@@ssj_sanguine4087 preludes are great to learn on! Hmmm there are few directions we can go to figure this out. Is there anything aftermarket done to the car like remote start? In my past experience when injectors aren’t firing then it’s usually an ignition related issue. Main Ignition relay, no fuel pump prime, remote start installed and it’s trash.

@ssj_sanguine4087

Жыл бұрын

@@thestateofreal2533 to my knowledge the only aftermarket things are the air intake and I guess he tried to rig a sound system. I’ve changed the main relay, new fuel pump, distributor, and many more things.

@thestateofreal2533

Жыл бұрын

@@ssj_sanguine4087 and I’m assuming you verified you have spark?

Do the grounds for the injectors matter what order they go in ?

@thestateofreal2533

Жыл бұрын

I’d bet money that it does not matter but I have to check.

@francisquinn9244

Жыл бұрын

@@thestateofreal2533 i think that the for red and black wires should be power and the other wires you showed in your vidoe would be the ones grounded in the ecu

Ok so I have a question and I hope you have an answer... So I saw your video about the crank sensor but I don't have the h22a4 but I have the h22a. Is there a distributor with a internal coil and crank? What should I do and what's the easiest way? Thank you

@EscoBoosted

4 жыл бұрын

So I think I found something... Does the TD61U distributor fit the h22? I think this one has both right?

@thestateofreal2533

4 жыл бұрын

The TD61U is externally coiled and has an external crank position sensor.

@thestateofreal2533

4 жыл бұрын

This distributor is a 2 & 8 pin which is usually externally coiled. Let me know if you need more help. Amazon is usually very helpful in describing the right distributor.

@thestateofreal2533

4 жыл бұрын

The best way to match up your distributor is to match the plugs pins. What’s going on with your dizzy that you want to replace it?