Homemade Air Compressor | Air Compressor Made From PVC!
Ғылым және технология
Hello Everyone!
This video is about a homemade air compressor. It's made out of pvc pipes, which are first being cut and converted into flat sheets
by heating with a butane torch. This sheets are then being cut into required dimensions for making the structure which includes the motor and the cylinder support and the cylinder itself.
For making piston, we used an epoxy putty (m-seal). The connecting rod made out of copper shaft and is soldered to the brass bearings, which acts as linkages.
As for the gears, they are taken out from old table fan. To make the crank a 3mm rod is attached to the gear, and is responsible for the reciprocating action of the piston.
For the value system we used small peices of balloon and works well for this compressor.
The motor is 12v dc , but it was required to operate it with higher voltage (19v), as it was not producing enough power at 12v.
So, this was all about how it was made.
Thanks for watching!
Creators: Deepesh and Deeptesh Chari.
Music: www.bensound.com
Пікірлер: 16
Very nice..
Muito interessante
Can you make a full tutorial ? This is the only DIY compressor got my interest.
@dcbuilds5719
2 жыл бұрын
Hello sir, it is great to hear that this compressor caught your interest, but it was just a prototype and may not be a perfect for long run as the piston wears out and also the cylinder wears out... But if you are still interested in making one we will upload the proper description soon. Thank a lot for showing interest!
Verry nice
@dcbuilds5719
Жыл бұрын
Thankyou sir!
This is so good.
One good advice... If you want better performance and efficiency at the piston area, pls check out videos on how airsoft or gel blasters piston works. Dont worry about the sudden explosive output pressure. Wont happen because you are not using springs.
@dcbuilds5719
2 жыл бұрын
Thank you sir!
Perfect, I´m sorry but I´m gonna copy in steel kkkk thanx, you're the one
@dcbuilds5719
2 жыл бұрын
Sure sir👍
Brother 😍
this way you spend more energy where very little energy is required. at the inlet place a non return valve cover piston outer and cylinder walls with sillica gel to reduce friction
@dcbuilds5719
3 жыл бұрын
Sir, it was our very first prototype though😅... and it was successful. And was our first time trying to work with pvc...and used whatever was there at home... Anyway, Thanks for your suggestion!
@pradeepchandra1734
3 жыл бұрын
@@dcbuilds5719 you are far better than many ppl who just play pubg and waste time doing nothing continue with the work the work you have done,.. improvise...make different models do watever you can but dont stop efforts all the very best
What use glue?? Name glue for pvc