Thank you Ash for that-- You are absolutely right ,the book-instruction manual has no detail whatsoever on how to correct this situation, and yet it is a simple fix thanks to you. A replacement table saw is no answer. again thank you.

@tahandcrafted

17 күн бұрын

Very welcome, after 6 months of use my biggest tip is that I have to check the blade for 90°every use, every time I pack it away it drops 0.15° and I cannot figure out why

Thanks from Czech Republic! My was also out of alignment!

these videos are super rare . no bullsht , no blabla , just short concise video that shows the issue and actually solves the problem . You just saved my nerves ( and i guess of many others ) ! xD

@tahandcrafted

2 ай бұрын

Thanks for the feedback, and that's the point right? Keep it to the point

Good details guy. thanks a lot.

This will also work for the Hitatchi C10RJ & Metabo HPT Jobsite Saw. Great video brother!

@Hansaman58

5 ай бұрын

Yes. They are the same saw under different brand names for different markets.

Well done Ash.....looks like you got that sorted out beautifully mate👍👍

Great help!

Thanks

Great vid mate. Mines only out by .6mm but it’s annoyed me no end. I’ll be fixing now for sure.

@tahandcrafted

5 ай бұрын

Thanks mate, appreciate your comments 👍

Just did the same to mine! Great vid thx

@tahandcrafted

7 ай бұрын

Was yours out also?

👍👍👍👏👏👏💪

Three months later.... How are you liking the saw, any good?

@tahandcrafted

4 ай бұрын

Can't complain, I absolutely love it, just always recheck the 90° after the 2 month mark, it had shifted to 89.5°

@Sly_Wolf_1

4 ай бұрын

@@tahandcrafted Thank you 🤝🏻