What did you do with the old power distribution pannel in the bottom? (The one for the motors. I forgot it's name). I am looking at making a setup with the normal SB405 Wing.

@Livinglifeat60

3 күн бұрын

I simply removed it. Made my connections direct to the flight control. Makes for a cleaner setup.

@alexanderanderson9929

2 күн бұрын

​@@Livinglifeat60Thanks for letting me know. I am assuming you attached the exposed wires like you would a EMC (or whatever it is called) to the pads on the controller?

@Livinglifeat60

Күн бұрын

@@alexanderanderson9929 You are correct.

Where does the capacitor go to?

@Livinglifeat60

2 ай бұрын

The cap goes to the power wires on the speed control. Solder it to the same pads as the main power wire connection.

@hobie278

2 ай бұрын

Ok great thanks for the reply

Don't buy this FC it's crap, I had rx uart problems, servo outputs went bad after five minutes on the bench while testing servos. I moved the servo output to S6 from S4 and got the servo working again but then the motor output on S2 went bad. Believe me, I pulled the servos and ESC all working fine with a servo tester. I even swapped the ESCs on the header pins S1 & S2 the problem just moved from not running the right motor to the left motor. Total Garbage!

@Livinglifeat60

3 ай бұрын

Thank you for your comment. I have 2 of the FC and no issues. You might of just got a bad batch.