Harvest Right Vacuum Error #9 Part 7 Epoxying the connector
We have started getting vacuum error #9 during the freeze and dry cycles.
In this series, we will be going over the steps we are taking to solve this problem.
I have seen lots of posts about this same error, and some still don't have any solution for the problem.
👉 The Freeze Dryer we have was manufactured in April 2022.
👉 We have only had it for a few months
👉 Currently we have completed 58 batches
We start out with the basic checklist and then work into the other possibilities.
Follow the series to see how it turns out.
✅ Part 1 - basic troubleshooting - • Harvest Right Vacuum E...
✅ Part 2 - checking for epoxy leak and off-gassing. - • Harvest Right Vacuum E...
✅ Part 3 - Testing the vacuum leak - • Harvest Right Vacuum E...
✅ Part 4 - Sensor leak finally fixed but still not working • Harvest Right Vacuum E...
✅ Part 5 - Fixing still another leak - • Harvest Right Vacuum E...
✅ Part 6 - Putting epoxy on the wires - • Harvest Right Vacuum E...
✅ Part 7 - Epoxy the connector - • Harvest Right Vacuum E...
Пікірлер: 8
Did you just use standard epoxy from Home Depot, etc?
@LearnToFixItYourself
Жыл бұрын
yes, I used the epoxy with 3000 psi strength because that is what I had on hand. The tech sent me a new wiring harness and this one had epoxy on both sides of the wires entering the tank. We found 3 places causing the leaks.
@mlydick
Жыл бұрын
@@LearnToFixItYourself what were the other 2?
Great video!
@LearnToFixItYourself
Жыл бұрын
Thanks!