@@andrisgulbis9677 hi, yes, but a thin paper layer as well to hold the paste itself. Bronze is the dead flat surface.
@andrisgulbis9677
Ай бұрын
@@kristofsom1822 I didn't even know it was possible, I'll try the same....I applied diamond paste to the copper disc, but there was a lot of dirt. After all up buying a yellow diamond rubber disc from aliexpress for 15 euros. Sorry for my bad english
@kristofsom1822
Ай бұрын
@@andrisgulbis9677 the paper is nessesery, it can take the paste, brass can't. This methode is way cheeper than the originel GRS yellow disc. And both do the same job.
@andrisgulbis9677
Ай бұрын
@@kristofsom1822 Thank you for your help and clarification, I will try what you are doing. Can you tell me if the paper is special or regular printer paper?
@kristofsom1822
Ай бұрын
@@andrisgulbis9677 it is slightly thicker than a printing paper, I have no specific information of it. You have to test them, after 3-4 different one you will find the right one I'm shure. Don't use so thick like a watercolour paper, the graver would sink into that low density paper and it makes the edge rounded.
Пікірлер: 7
Hi, diamond paste on a bronze disc?
@kristofsom1822
Ай бұрын
@@andrisgulbis9677 hi, yes, but a thin paper layer as well to hold the paste itself. Bronze is the dead flat surface.
@andrisgulbis9677
Ай бұрын
@@kristofsom1822 I didn't even know it was possible, I'll try the same....I applied diamond paste to the copper disc, but there was a lot of dirt. After all up buying a yellow diamond rubber disc from aliexpress for 15 euros. Sorry for my bad english
@kristofsom1822
Ай бұрын
@@andrisgulbis9677 the paper is nessesery, it can take the paste, brass can't. This methode is way cheeper than the originel GRS yellow disc. And both do the same job.
@andrisgulbis9677
Ай бұрын
@@kristofsom1822 Thank you for your help and clarification, I will try what you are doing. Can you tell me if the paper is special or regular printer paper?
@kristofsom1822
Ай бұрын
@@andrisgulbis9677 it is slightly thicker than a printing paper, I have no specific information of it. You have to test them, after 3-4 different one you will find the right one I'm shure. Don't use so thick like a watercolour paper, the graver would sink into that low density paper and it makes the edge rounded.