You should really add all your Part Numbers you bought in the description! nice vid though.

You need between .100 and .150 of clearance as the clutch wears the fingers or forks move towards the bearing. The bearing should NOT be turning when you release unless you enjoy replacing it often. You cannot preload the diaphragm of the pressure plate, ever...

@Boostmonger_Jon

2 жыл бұрын

Yes. I didnt realize when i put it together. Has been corrected

I personally would have went back and put a 90 or at the very least a 45 on that bleeder line just because I worry about rub through and I hate redoing work.

So what bell housing are u using

WHich trans are you running

How did this turn out? It seemed that you spent little time adjusting the clearance. Looking at speedways directions it said to have .050-.100" clearance, which is not at all what you said in the video. Did you have to reset your clearance?

@Boostmonger_Jon

4 жыл бұрын

Oh interesting, i think i got my specs from another channel. But as of yet its still unfinished, so i may very well have to reset it.

Does that throwout bearing bleed ok? I oriented mine as upward as possible to let the air travel upwards to make it easier.

@Boostmonger_Jon

Жыл бұрын

Yeah it bled quite easily. Works great!

Do you have any update on this install? I had this set up trying to do it with a Muncie 4 speed on an aluminum 5.3, and Im curious to see how you adjusted it after the fact

@Boostmonger_Jon

Жыл бұрын

I actually havnt adjusted it at all. Probably could take a shim or 3 out of it. Not enough pedal free play

use right angle fitting

would a t56 slave cylinder and throwout bearing work ??

@Boostmonger_Jon

5 жыл бұрын

Honestly im not sure. I should have spent more time researching perhaps.

@anthonymacon01

5 жыл бұрын

BoostMonger oh ok bc I'm doing a build on my channel and i have that trans and a ls2

@Boostmonger_Jon

5 жыл бұрын

That will be slick! I look forward to seeing your progress

@anthonymacon01

5 жыл бұрын

BoostMonger TZ-NatioN87 lol , Look me up .

Not using the metric system is such a pain in the ass. All kinds of unnecessary math and fractions instead of mm 9+10=? 31-9=?

you just screw up, that fitting you installed with JB weld is going to come loose later

@Boostmonger_Jon

3 жыл бұрын

Well thats unfortunate..