Thank you so much for these videos. I am learning so much that a lot of other guys don’t even bother to cover on this subject. Thanks so much man. 😁😎👍🏻

@vikingmech

Ай бұрын

@gimmefuel7268 No problem brother! I do try to cover things that I just can't find other videos on. Thanks for watching and commenting.

Great video! I appreciate the attention to the small details! So far this is the only video I've been able to find showing installation of the needle bearings and seal inside the spindle. Thanks!

@vikingmech

4 ай бұрын

@carterdrake5283 Great, I'm glad it was helpful for you! Thanks for watching and commenting!

I used a long piece of all thread and attached a big washer between 2 nuts. I used that to scrape all the dirt out of the axle housing and then used a shop vac with some old attachments to further clean it up and it worked well.

@vikingmech

17 күн бұрын

@WeekendPursuitOutdoors Good idea. Sounds like that would work better than my paper towels!

There is a procedure

Part number on the ball joint socket please

@vikingmech

2 ай бұрын

@vagabond3045 Not sure exactly what you mean by ball joint socket, but I put links in the description to the 2 special sockets I used. Is that what you're looking for?

I have a jeep with this axle swapped. It is hard for me to find the right parts. What hubs are those? What vehicle would i say it goes to? Everything i have looks the same as yours. Awesome video by the way.

@vikingmech

2 ай бұрын

@charlesdudding2095 Mine is just a very common GM 10-bolt. I got the hubs from ORD here: www.offroaddesign.com/warn-10-bolt-or-dana-44-internal-style-locking-hubs-fits-all-1-2t-gm-axles-and-77-and-newer-3-4t.html

@vikingmech

2 ай бұрын

And if you're looking for other parts, you could just look up something like a 1985 GM K10 or K20 pickup. They would all have either the GM 10-bolt or a Dana-44 which are nearly identical axles.

@charlesdudding2095

2 ай бұрын

Thank you so much for the help. Once again awesome videos. They helped me a lot.

@vikingmech

2 ай бұрын

@@charlesdudding2095 Great to hear that feedback. Thanks for the comments!