Man I have to say, this is the least elegant solution I’ve seen on a Festool yet. A single piece of t-track between the extensions and saw on each side is all it would take.

The problem with just clamping the scrap board as shown at 7:27 is that is just held by friction. Clamping the Crown creates forward movement which causes the cuts in the spoil board to shift. You can see the misaligned cut at 7:36

thnx for the vid! can't understand why such good information does not come from the german festool dudes. now i think gonna buy the " crown stops", in german called "Winkelabstützung AB-KA-UG/2" ! ;)

you can install extensions in oposit sides and that will give you edge to res your crown

Just follow these 82 steps and its that easy!

@OneTequilaTwoTequila

2 жыл бұрын

No kidding! Love the saw, but this attachment is unnecessarily complicated. I'll pass!

When you reference another video please post a link to it. I'm having trouble finding it

Love Festool, but need to mortgage the house to buy it! 😁

@ThisTall

3 жыл бұрын

That’s because their manufacturing employees are the only ones amount tool brands that can also afford an American mortgage. They cost exactly what they should.

@tundrawhisperer4821

3 жыл бұрын

Kermit huh? Lost me. Are you saying they get paid very well?

Geez, would have had the job done by the time the guy with the kapex set his unit up🤣🤣

can i use the crown stop with out the wings?

So we have the capability to cut tall crown at the chop setting. But to see the laser we have to disable the special chop setting. What!?

trop compliqué....