Thanks for always helping educate the airgun community Ernest.

Só posso dizer parabéns é sucesso é que sonho com uma ainda customizada por você só felicidade like garantido sempre vídeos top

Thank you!.

thanks for sharing your knowledge, i already learned a lot to see your vidios ... a hug from Portugal It is possible to buy, and send to Portugal

What is the outer diameter of the brass tube/port? Is it 12mm?

Hope they come pre-center punched to save some confusion and possible stress on those of us that are less incline on the modification front but still want to make the most of an amazing tool/ mod. 🥃cheers🍻

@ernestrowe5061

3 жыл бұрын

-> the milled alignment slot is your center reference to drill the low power TP

Hey Ernest, you got one of those for a Impact .357?

I got it today in the mail looks awesome one question what's that extra oring for the inside of the barrel sleeve hmm

@ernestrowe5061

3 жыл бұрын

Chris Figueroa --extra probe oring, its little larger then standard to last longer without affecting accuracy

Thank was good I got this barrel ...but can it fire off slugs

@ernestrowe5061

2 жыл бұрын

Was designed for slugs and pellets

I'm looking for one for my FX Crown M1.

Mine come with it. Just found out today that’s why my velocity was down even with the regulator turned up. They shipped it to me with the small barrel port side down.

Thanks

Thanks ernest awesome stuff...I got a leak on my impact boo woo 😭

@ernestrowe5061

3 жыл бұрын

Chris Figueroa fix it

@chrisfigueroa3361

3 жыл бұрын

@@ernestrowe5061 I don't know how... I had my gun set to shoot 36.2 gr nsa at 935 fps and yesterday I ran out of nsa ..so I took the bottle off blead the air by turning the reg counterclockwise then I lowered the reg to 120 i tuned the gun to shoot 26 gr hybrids at 945 perfect tune spot on at 50 yards left it at 200 bar went work this morning got home it was at 148 bar 😭

@peteralexben

3 жыл бұрын

@@chrisfigueroa3361 the parts that you removed and mounted back, there is a O ring damaged , use silicon lube and new o rings ,or in the regulator they bleed air . use soapwater to find the leak

RED locktite??

@ernestrowe5061

3 жыл бұрын

Blue or red just let cure overnight

@KevinWood44

3 жыл бұрын

@@ernestrowe5061 I thought red was permanent and very hard, if not impossible to get off?

@ernestrowe5061

3 жыл бұрын

@@KevinWood44 - funny its easy for me- i just heat enough to break loose- that was easy!

@KevinWood44

3 жыл бұрын

@@ernestrowe5061 Well when you need an apprentice, let me know and you can teach me all the tricks 😁

Dual

@ernestrowe5061

3 жыл бұрын

R Kave --> Thanks 😊

@06rkave

3 жыл бұрын

@@ernestrowe5061 Thank you, excellent videos