Full Detail!! MC2 Motor Mount and Brace install for Arrma Vorteks and All 3S Models!!
Hi Gang,
Watch this video on the MC2 Motor Mount and Chassis brace for the Arrma Vorteks and all other Arrma 3S models!
I install this motor mount to dress up my Arrma Vorteks as well as to add a little more reliability, strength, and looks to the vehicle.
You can get this item here:
m2cracing.net/79-arrma-vorteks
Thank you Everyone for your increasing Support of my Channel!
I will continue to create fun, interesting, and helpful videos as best I can!
You can email me at:
watsnu2day@gmail.com
Visit new and upcoming videos on Instagram:
@watsnu2day
Support my channel by giving a small donation to:
Paypal: kjaba808@gmail.com
Пікірлер: 25
9:00...great idea !!!! Magnetic floor. When the screw drops it doesn't bounce halfway back to China. They always seems to find the futherest place to go under the hardest thing to move. LOL
Looks like a beefy motor plate and brace ! Should do the trick !
Nice setup. It doesn't take much to bend the stock motor plate. The MC2 motor mount seems like a great solution. Thanks for sharing.
Thank you for the drill bit explanation. I've been looking for awhile.
Hi mate. I use Loctite bearing mount to take any loosens out and secure the bearing.
@watsnu2day
11 ай бұрын
Good tip! Make sure to like and Subscribe to the channel!
Cool man. I used the Integy one but I do like the material and design of the M2C
@watsnu2day
2 жыл бұрын
Thanks!
cool motor mount and brace,great install
Very nice piece. Are your Trenchers belted? Like them?
Good video!! Just curious about the turnbuckles. Did you make those or order them. I'm new to the hobby and have a Vorteks myself.
Salute great content stay up can u give me name & product # on those tires appreciate you if so Godbless
Any idea what the threaded hole on right of mount is for its not used.
what washers did you use for the 2 motor screws?
Mine my motor mount bend when i bump in a manhole. Now i have hot racing because mc2 is a little expensive
Have you tried or looked into upgrading your differentials? I tried to upgrade mine and found the pinion is to long to slide my motor assembly in all the way for it to click in.
@watsnu2day
2 жыл бұрын
Did you upgrade to a metal gear and output shaft? If so, I believe that when you do, there is a part number for a shorter metal output shaft from Arrma. I used the shorter metal gear when I used the HR yolk and metal diff gear.
Where you buy that motor mount @?
I think you forgot to Loctite the motor mount screws. U did the grub screw but not those.
@watsnu2day
2 жыл бұрын
Its ok.i check them once in a while. I just hate using neat or my soldering iron to break loktight on screws that can potentially strip or brak.
@ubreakitirepairit3569
2 жыл бұрын
@@watsnu2day Ooh okay. Very rare to strip an M3 hex head screw. Blue loctite is removable w/o any heat.
Is it worth it since you put it in? Thanks
@watsnu2day
2 жыл бұрын
I dont bash or do high jumps, but if you do, it will not bend as easy as the oem motor mount.
@watsnu2day
2 жыл бұрын
also, i like the look of it and with the slightly bigger Mojave v2 motor in it, better safe than sorry even though a stock replacement isnt expensive anyways
Waffle, Waffle, Waffle.... 24 minutes.