FS-i6 & FS-iA6B binding, FS-CVT01 voltage sensor installation - Transmitter : FS-i6 - Receiver : FS-iA6B - Voltage sensor : FS-CVT01 from banggood bit.ly/3b5yKZH
Жүктеу.....
Пікірлер: 16
@owlbruno3 жыл бұрын
Super,, Danke für das tolle Video,, 👍🍺
@josephbonney72553 жыл бұрын
Thanks so much! This was very helpful. I've had the TGY i6 transmitter for over a year, and I finally got a telemetry receiver, but I wasn't sure how to use it. This really cleared it up. Can you install two sensors? I'm not sure if I can install an altitude sensor in the servo/s.bus port.
@PeterAbt4 жыл бұрын
Thanks for the Video! Do you know if there is any way to turn of the Voltage Alarm? Because when I have my motor on - full throttle the voltage drops down quiet drastically - so low - that the alarm goes off. But I want to keep the high- low-voltage settings so that there I can keep the beautiful battery animation at the top right corner of the display.
@jayrermars84934 жыл бұрын
Hi, my receiver came with red rubber on the ends of the antennas, just as yours have black rubbers in the vid. Should these be removed or not? Many thanks.
@RCstagram
4 жыл бұрын
Antenna cable noise filter inside the tube. Don’t remove it.
@aqkhana20023 жыл бұрын
Can you help me in my radio i can see err 1:0% what that mean ?
@stewm400driver3 жыл бұрын
Can this voltage sensor be used with other brands of RX?
@RCstagram
3 жыл бұрын
Mark Stewart I don’t think so.
@chrisgiles53893 жыл бұрын
how many models memorys does this have?
@RCstagram
3 жыл бұрын
Up to 20 models.
@arnoudwalrecht84793 жыл бұрын
Question: can I operate two sensors (volt and temp) at the same time? Thanks a lot
Пікірлер: 16
Super,, Danke für das tolle Video,, 👍🍺
Thanks so much! This was very helpful. I've had the TGY i6 transmitter for over a year, and I finally got a telemetry receiver, but I wasn't sure how to use it. This really cleared it up. Can you install two sensors? I'm not sure if I can install an altitude sensor in the servo/s.bus port.
Thanks for the Video! Do you know if there is any way to turn of the Voltage Alarm? Because when I have my motor on - full throttle the voltage drops down quiet drastically - so low - that the alarm goes off. But I want to keep the high- low-voltage settings so that there I can keep the beautiful battery animation at the top right corner of the display.
Hi, my receiver came with red rubber on the ends of the antennas, just as yours have black rubbers in the vid. Should these be removed or not? Many thanks.
@RCstagram
4 жыл бұрын
Antenna cable noise filter inside the tube. Don’t remove it.
Can you help me in my radio i can see err 1:0% what that mean ?
Can this voltage sensor be used with other brands of RX?
@RCstagram
3 жыл бұрын
Mark Stewart I don’t think so.
how many models memorys does this have?
@RCstagram
3 жыл бұрын
Up to 20 models.
Question: can I operate two sensors (volt and temp) at the same time? Thanks a lot
@feltav5719
Жыл бұрын
Same question... Any answer?
@arnoudwalrecht8479
Жыл бұрын
@@feltav5719 yes, just connect them through
@feltav5719
Жыл бұрын
@@arnoudwalrecht8479 through what?
@arnoudwalrecht8479
Жыл бұрын
@@feltav5719 each other haha
@feltav5719
Жыл бұрын
@@arnoudwalrecht8479 gotcha lol