Ford Territory SZ 2.7L Diesel P123A and P023D, AJD-V6, DT17, DT20
This video discussed the causes and troubleshooting of P123A and P023D in Ford territory SZ Diesel 2.7L. The engine is shared with other car mufacturers like Jaguar, Citroen, Peugeot and Land Rover hence the troubleshooting should be similar.
Пікірлер: 14
Nice explanation! 😉
13:15 or maybe MAP sensor is dirty? Mine was literally plugged full of gunk. Took 5 mins to clean. But you make a good point about the PCM barometric pressure comparison to MAP at start up.
@theogharoon
Жыл бұрын
Learning lots from your videos. Keep em coming
@RZJugaar
Жыл бұрын
True that's correct.. MAP sensor is the primary culprit and end up with piles of soot that can prevent it from proper measurement...
Thank you for the very detailed video. Can I assume you have experienced this fault on a Ford Territory and what was your rectification?
@RZJugaar
Жыл бұрын
Yes, I just fixed p123A on my territory. P023D discussion is fault analysis and online read up of multiple accounts of people who faced it
Hi mate I have problem where territory diesel shows DSC faults when preasing on accelerator .
@RZJugaar
Жыл бұрын
Scan it and report the codes here. Only then I'll be able to point you in a direction
I’ve cleaned a bunch of sensors with mad cleaner and now I get a engine light, cruise unavailable. And the car doesn’t rev above 2500rpm and and has gone into limp mode. Any idea why this may of happened or what I can do to reset? I’ve got an obdII TOOL and have reset the codes but no luck, I’ve reset the battery no luck
@RZJugaar
2 ай бұрын
Can you read the codes using scanner and share? Mad cleaner you mean the stain remover?
@anels9
2 ай бұрын
@@RZJugaar the only code I got was the p0237 and sorry type, meant maf cleaner (crc brand)
@RZJugaar
2 ай бұрын
@@anels9 carefully remove your boost sensor (the one shown in the thumbnail of this video). Inspect and put it back. Make sure it's properly connected. If you still have the problem then your sensor has gone faulty and you need a new one.
@anels9
2 ай бұрын
@@RZJugaar yes I still have the problem. Is thumbnail a pic of the map sensor?
@RZJugaar
2 ай бұрын
@@anels9 yes and no. it's a boost pressure sensor but since both map and boost sensors measure the pressure, the terms are used interchangeably.. In your case the boost pressure sensor is gone.. you'll need a new one.