Fix Temperature Gauge not working! Ford 7.5l (460ci)
Жүктеу.....
Пікірлер: 24
@newageguitar Жыл бұрын
Thank you for letting me know where that bad boy was, makes my work a whole lot easier on my 94 Winnebago.👍👍👍
@umpquaoutdoors
Жыл бұрын
I'm so glad it helped you.
@volkmarmaleika1623 Жыл бұрын
Thanks for your well documented fix. I have a 74 Mercedes with the same problem, but hope it is the sender, not the gauge. Will know tomorrow.... Thanks for your video, VW
@guitarmi8212 Жыл бұрын
That was really Helpful. Thanks
@bellasvistas34639 ай бұрын
I changed my sensor Ford E-150 5.8L W. It was reading very low all the time with the new sender in it reads above the 1/2 way. Still in Normal Range but above 1/2. I measured the temp with a digital thermometer at 159 F. Mike
@charlescrail3141 Жыл бұрын
Great video to the. Point very helpfully
@dominicpacione74702 жыл бұрын
Great vid thanks!
@umpquaoutdoors
2 жыл бұрын
Glad it helped
@longshot82383 Жыл бұрын
Great video straight to the point Thanks
@umpquaoutdoors
Жыл бұрын
Hope it helped👍
@midnightadventureswa Жыл бұрын
Great job do you know on a video? Out there for the light on your van for the shifter indicator on the steering column ?????
@martinlandaverde403 Жыл бұрын
How about if my conector have two prongs.???
@thezackperry24 Жыл бұрын
You hero
@umpquaoutdoors
Жыл бұрын
Thanks - but I haven't worn a cape in a while.
@thezackperry24
Жыл бұрын
@@umpquaoutdoors also do you have a part number and store you got the replacement from?
@umpquaoutdoors
Жыл бұрын
@@thezackperry24 I got it on Ebay: www.ebay.com/itm/334171084206
@thezackperry24
Жыл бұрын
@@umpquaoutdoors throw that cape on lol
@ross7987 ай бұрын
Same issue on a 96 Ranger with the 3.0. Ground sender, gauge pegs to hot. So, not the instrument cluster. Drive for a while, gauge will stay pegged below cold, even when engine is hot, then later, after thermostat opens, then gauge will suddenly move to the center, takes around 15 minutes. Ford thought it was the Sensor, since I already changed the Sender AND I checked the Sender wire and it is making a good electrical connection. So, changed the sensor too, same issue. So, still unsolved.
@umpquaoutdoors
7 ай бұрын
My guess is the thermostat is sticking/bad. It sounds like it's sticking till it gets warm and then finally pops open and probably gets stuck in that position. I have a '98 Ranger 4.0 and when I first bought it the thermostat was stuck wide open, The gauge never moved, the motor didn't warm up much and the heater didn't put out any heat.
@alexherrera4877 Жыл бұрын
I have en ford 1997 E350 econoline I changed the same sensor but still sending the same code and still not reading the temperature.. Anything else I could do on this?
@juangodoy52
4 ай бұрын
Ever find out the problem? Dealing with this exact problem right now
Пікірлер: 24
Thank you for letting me know where that bad boy was, makes my work a whole lot easier on my 94 Winnebago.👍👍👍
@umpquaoutdoors
Жыл бұрын
I'm so glad it helped you.
Thanks for your well documented fix. I have a 74 Mercedes with the same problem, but hope it is the sender, not the gauge. Will know tomorrow.... Thanks for your video, VW
That was really Helpful. Thanks
I changed my sensor Ford E-150 5.8L W. It was reading very low all the time with the new sender in it reads above the 1/2 way. Still in Normal Range but above 1/2. I measured the temp with a digital thermometer at 159 F. Mike
Great video to the. Point very helpfully
Great vid thanks!
@umpquaoutdoors
2 жыл бұрын
Glad it helped
Great video straight to the point Thanks
@umpquaoutdoors
Жыл бұрын
Hope it helped👍
Great job do you know on a video? Out there for the light on your van for the shifter indicator on the steering column ?????
How about if my conector have two prongs.???
You hero
@umpquaoutdoors
Жыл бұрын
Thanks - but I haven't worn a cape in a while.
@thezackperry24
Жыл бұрын
@@umpquaoutdoors also do you have a part number and store you got the replacement from?
@umpquaoutdoors
Жыл бұрын
@@thezackperry24 I got it on Ebay: www.ebay.com/itm/334171084206
@thezackperry24
Жыл бұрын
@@umpquaoutdoors throw that cape on lol
Same issue on a 96 Ranger with the 3.0. Ground sender, gauge pegs to hot. So, not the instrument cluster. Drive for a while, gauge will stay pegged below cold, even when engine is hot, then later, after thermostat opens, then gauge will suddenly move to the center, takes around 15 minutes. Ford thought it was the Sensor, since I already changed the Sender AND I checked the Sender wire and it is making a good electrical connection. So, changed the sensor too, same issue. So, still unsolved.
@umpquaoutdoors
7 ай бұрын
My guess is the thermostat is sticking/bad. It sounds like it's sticking till it gets warm and then finally pops open and probably gets stuck in that position. I have a '98 Ranger 4.0 and when I first bought it the thermostat was stuck wide open, The gauge never moved, the motor didn't warm up much and the heater didn't put out any heat.
I have en ford 1997 E350 econoline I changed the same sensor but still sending the same code and still not reading the temperature.. Anything else I could do on this?
@juangodoy52
4 ай бұрын
Ever find out the problem? Dealing with this exact problem right now
@juangodoy52
4 ай бұрын
@alexherrera4877
Hi did your cooling fan turn on properly?
@umpquaoutdoors
5 ай бұрын
I have a mechanical cooling fan (run by a belt).