First time installing pole lights epoxy bolts.
Ойын-сауық
We didn’t have the pole lights when it was time to set the bases so they were poured without anchors. Then we used epoxy and threaded rod to anchor the pole lights. Also added 70volt speakers to the poles for some tunes while at play.
Пікірлер: 13
Awesome job!! It’s brave to show your work on KZread these days with all the comments, but you deserve some love for this!
@electricianjoe
Жыл бұрын
Appreciate that. I have thick skin 🤠
Awesome! Looks great
I pre build jigs that match the pole base flanges and set the bolts while the concrete is wet.
@electricianjoe
Жыл бұрын
That’s how I’ve always done it but this way is much easier and faster. Highly recommend
Fucking awesome great job!
@electricianjoe
Жыл бұрын
Thanks. Appreciate it
When pulling the speaker wires through did you Seal the holes to make sure nothing gets through Or left it over for a drain?
@electricianjoe
Жыл бұрын
We did not seal them but the wires are waterproof. So we would just pull them out and blow out the conduit if anything ever needed replaced 👍
@DiyintheGhetto
Жыл бұрын
@@electricianjoe It's not the wires that I'm wondering about. It's the connection boxes.
Why do you run a ground wire if you’re driving a ground rod? Does that ground rod and ground wire meet the requirements for the egc of the system since you are driving a ground rod?
@electricianjoe
Жыл бұрын
Ground rod is for each pole. Egc is for the circuit.
Hi