Fiesta Mk6 Oil Change, Gearbox Oil Change, Reverse Switch Change
Фильм және анимация
In this video, I set about changing the engine oil the gearbox oil and the reverse sensor switch on my Mk6 Ford Fiesta!
My Fiesta is now 195,000 miles and it needs to be looked after more than ever!
Oil Change video:- • Ford Fiesta MK6 Zetec ...
Gearbox Oil:- amzn.to/43d7Rzr
Engine Oil:- amzn.to/48MK0I0
Disclaimer:- McLaren Media & McLaren_Automotive_Photography present the facts and content in these videos on a strictly fun and informative basis, these videos are not guaranteed to be 100% accurate.
McLaren_Media and all associated names assume no liability for property damage or injury incurred due to any information in this video. Use this information at your own personal risk.
McLaren_Media always recommends safe working conditions and the correct tools and safety equipment before undertaking any type of vehicle repair or photography shoot of any nature.
No information shown in any video will result in any expressed or implied warranty or guarantee of any personal results.
Injury, damages, loss or health implications that may result from improper use of tools, parts and unsafe hazardous working areas or locations and from the information in this video is the sole responsibility of the user and not McLaren_Media.
Titles and Idents available at:-
www.productioncrate.com/#ref=...
Redbubble Shop:-
www.redbubble.com/people/McLa...
PICFAIR Shop:-
mclaren-media.picfair.com
Пікірлер: 6
How tight did you screw the reverse switch in, mine snapped with the slightest of effort probably the cheap gsf part tbf. Good vid 👍🏼
You need the biggest can of brake cleaner ever made to clean all that oil off everywhere.
I read not to open the bottom plug as it's not intended as a drain plug. How accurate that is I don't know. Also you jacking the car up like that limits how much drains out from the gearbox.
@GeoffDecorator
2 ай бұрын
Personally I would raise the whole car level enough to work on with 4 axle stands with two heavy Jack's as a back up , and make sure you do it all when the oils are hot so it runs out faster and easier.
@Harryd06
26 күн бұрын
well it worked didnt it lol, why else would it be there i understand it may be some sort of bearing for the gears, but its fine, since its in netrual lol
@norm4260
26 күн бұрын
@@Harryd06 "That is not just a bolt but the locking bolt of the selector shaft. I have seen before that people who used this bolt to drain the gearbox ended up disassembling the gearbox because they could not get the bolt back in because parts of the selector mechanism came loose inside the gearbox. Personally I would not use this locking bolt to drain the gearbox. Ford does not prescribe any method to drain the gearbox because it is considered to be filled for life."