very nice and clean! Can I use the same instructions and material to set up for a FH220?

@yavuzyavuzer

Жыл бұрын

Yes, same instructions for FH 120/220/55/255.

Anyone ever get an ee 03 error code? Online it says low flow or low water. Nothing seems unusual, so I'm not sure how to fix it

I read a review on Amazon that says this unit will also cool if you set the temp lower then the actual pool temp. Is that correct?

How long does it take to heat up a 18 ft round above ground pool?

how do i change deg F to deg C om the display panel?

@Fibropool

Ай бұрын

Hey Piotr, our previous generation of heat pumps aren't reprogrammable, so switching between F and C would require you to physically change the display. If you'd like, you can open a support ticket with us on our website and we can get one sent out to you ASAP.

Question.. My fibro heat pump is about 5 months old been running like a champ but now the fan wont kick on to heat the pool. Temp is set for 82. Gage current says 80 in 79 out. Filter is clean, pump is running strong, water level is on point but nothing. Any suggestions?

@Fibropool

3 жыл бұрын

Ryan Morales Try to change the temp to 84’f and see if it comes on. When the set temp and actual temp are too close to each other, the heater will not kick on. And the logic behind that is; 80 in may be 80.4. But it will round to the nearest number. And it needs 2 degreed difference to kick on

@sinoa03

2 жыл бұрын

@@Fibropool i just purchased mine and the fan is not kicking in. Turned it on and 20 minutes later, it’s all frosted. Please help.

@yavuzyavuzer

Жыл бұрын

@@sinoa03 if the fan doesnt come on, perhaps jammed or blocked fan, the coils will frost up.

When ever I press the up and down button the value doesn’t flash

An it stay inside a pool house or must it stay outside

@Fibropool

11 ай бұрын

Heat pumps need to be kept in an outdoor environment to work properly. There's generally not enough moisture or heat indoors to allow it to work.