FIAT Climate control repair guide

Пікірлер: 31

  • @ivanzurga6121
    @ivanzurga61212 жыл бұрын

    Where you bought spare parts, caps that go on the engine?

  • @ThePeopleVerse
    @ThePeopleVerse11 ай бұрын

    Sh*t .... Thanks for the informative video and the luck. We just duscovered this issue today. Time for a deep dive into this area of Fiat maintenance. 😂 😢

  • @onnaj10000
    @onnaj100002 жыл бұрын

    Hi, in my Delta III (basically a Fiat Bravo) I have the problem the climate control is only getting cold when I set the temp to 16 degrees or lower. Even @16 degrees it's a bit warm. Is this also caused by the plastic parts? And I guess with LHD I'd find the motors on the passenger side? Thanks!

  • @kieronsimm9562
    @kieronsimm9562 Жыл бұрын

    That is the easy two to replace, try replacing the recirculation door one without taking the dash out.

  • @gonzalo1972

    @gonzalo1972

    2 ай бұрын

    Is it even possible? without the dash out job?

  • @rmg4076
    @rmg40762 жыл бұрын

    Hi, sorry for my english, is not my language :( I have the same problem but not in passenger side, i have this problem on driver side Both eletcric motors are in passenger side? (both i mean motor for passenger side and motor for driver side) Or i need to remove panel from driver side, under steering wheel? I hope you understand what i try to say :D Thank You very much!

  • @foreveryoung3907
    @foreveryoung39072 жыл бұрын

    Hi I have a Fiat 500 changed the heater matrix and since I have I have to bang the side of the dash for it to blow hot air is this what could be causing it , or I can mess with the buttons and sometimes it works

  • @MrBuinickas

    @MrBuinickas

    2 жыл бұрын

    Hi Sounds like you have bad blower motor or its connection. Good luck

  • @buddylee4177
    @buddylee41772 жыл бұрын

    Hi thanks for the vid. Would this be the same if my heaters are blowing cold even though the engine is hot, I’ve checked the anti freeze as I’ve changed water pump and thermostat and bled system but still blowing cold air. Look forward to your reply

  • @MrBuinickas

    @MrBuinickas

    2 жыл бұрын

    Hi Yes you have exactly that problem. The flaps are not moving. Regards

  • @buddylee4177

    @buddylee4177

    2 жыл бұрын

    @@MrBuinickas thank you for such a quick response is there a way to check this

  • @buddylee4177

    @buddylee4177

    2 жыл бұрын

    I’ve also noticed on a lot of forums as I’ve been scratching my head with it all. That there is a grave in the uk that puts a self tap screw through them, but from your vid it looks just as good to replace the plastic clips rather than drilling through the spindle. Or ive got confused with other issues

  • @MrBuinickas

    @MrBuinickas

    2 жыл бұрын

    ​@@buddylee4177 to check it is obvious, one side changes temperature other side doesnt if there one side flap not working. Ad there are possibility that main flap got stuck then both sides stays on same temp.

  • @MrBuinickas

    @MrBuinickas

    2 жыл бұрын

    @@buddylee4177 I'm sorry but I can't comment on that, I don't realy understand what you realy mean.

  • @johnmichalopoulos687
    @johnmichalopoulos6874 жыл бұрын

    After you put the motors Did you do some kind of reset?

  • @MrBuinickas

    @MrBuinickas

    4 жыл бұрын

    Hi John No reset or other manipulation is needed. Installing and enjoying. Regards

  • @johnmichalopoulos687

    @johnmichalopoulos687

    4 жыл бұрын

    @@MrBuinickas Thank you!

  • @fig4snick
    @fig4snick3 жыл бұрын

    Excellent work... But why everyone else completely take off the dashboard? There isn't good enough access to remove them.?i have even see some people to cut off a bit to gain access.

  • @MrBuinickas

    @MrBuinickas

    3 жыл бұрын

    Hi no not at all There are plenty of room for this job to get done. Good luck

  • @fredmatubia1471
    @fredmatubia14714 жыл бұрын

    very helpful demo there,its good to know that i dont have to bring down the whole dash ,as some are doing, however my car has a similar issue but slightly different , the passanger side vents only blowing cold air despite setting the temperature high, however the driver side am getting hot air but on ly at the winscreen vent, the center vent seem to be blocked even though i can feel the hot air trying to sneak out. what do you think i need to look at. thanks

  • @MrBuinickas

    @MrBuinickas

    4 жыл бұрын

    fred matubia I head exactly same problem as yours. There are 6 mentioned in video plastic parts. I replaced 3 and everything worked perfectly since. Good luck

  • @johnmichalopoulos687
    @johnmichalopoulos6874 жыл бұрын

    this is a right wheel drive car, right? so is it the same to fix it with a left wheel drive car? i dont think so... i am wrong?

  • @MrBuinickas

    @MrBuinickas

    4 жыл бұрын

    john michalopoulos Should be exactly the same. Regardless location of drivers position.

  • @Stepsglass
    @Stepsglass Жыл бұрын

    Hi great video Do you know where can I get this work done in London?

  • @MrBuinickas

    @MrBuinickas

    Жыл бұрын

    Hi Any garage. Show them my video. regards

  • @rmg4076
    @rmg40762 жыл бұрын

    Repost but with better english :) Hi, sorry for my bad english, I am not a native speaker :( I have the same problem but not on the side of the passenger, but on the driver side. I was wondering if both electric motors (passenger side + driver side) are on the side of the passenger? Or do I need to remove panel from driver side under steering wheel? I hope you can understand what I am trying yo tell you :D Thank u very much!

  • @MrBuinickas

    @MrBuinickas

    2 жыл бұрын

    Hi Yes both motors (in fact 3 motors) are on the same side. Regards

  • @rmg4076

    @rmg4076

    2 жыл бұрын

    @@MrBuinickas Thank you very much for info :D

  • @Silver-Nick111
    @Silver-Nick1113 жыл бұрын

    EXCELLENT!