2:20 "I'd rather a tight hole than a sloppy one any day" Put that on a t-shirt. 😅🤣😂

@FarmLearningTim

Жыл бұрын

Hmmm good idea.

@arffadailey8055

Жыл бұрын

Cum on Tim. This is a family show.

@simongibbs9392

Жыл бұрын

Nothing wrong with a sloppy hole. 🤤

As always I get a good chuckle at the intro when you laff after welding 😂😂 looks like a good product and thanks for the tip of using a plumb Bob ( string and a big nut ) to locate plumb for the holes

wish i knew about this gate hinge kit a week ago, i lived the usual nightmare trying to hang a gate, keep up the great content mate - Rob (Century Rain)

Good morning, Tim, excellent video, I have really struggled with the previous gate hinge kit that you had there at the start of the video. I will be getting a couple of the kits just to have for my next fence & gate job. Cheers, and love the channel.

Nice. I’ve hinged a lot of gates on timber posts with the traditional hinge kits and can see the speed benefits with this one

Acme thread is a great idea.

Great video as usual Tim keep em coming. Cheers.

Nice One Tim Thanks again

I like the idea of this hinge kit. The standard hinge kit I use has a few draw backs, like the latch for the top hook sometimes flies off making the gate moving and the gudgeon pin being relatively short. I hope the rototech kit can hold the weight of the gate, after it was installed for a while and swung open and close many times.

I love this kit. This simplicity of it, brilliant 👏.... tight hole 🤣🤣🤣

very interesting - we pretty much as standard have 2 hole only hanging kits here in the UK.

@FarmLearningTim

Жыл бұрын

Almost all 4 pin or bolt on here.

Gday Tim, nice design hinge kit. I notice you install the gate between the gate posts rather than on the side. Is there any reason for this? I was always taught to install on the side of the post, which allows the gate to swing 180 deg. That way when you're moving livestock through a gateway, there's no way for animals to get behind the gate. Keep up the good work

@FarmLearningTim

Жыл бұрын

Yeah I’ve done that as this gateway is used to get the tractor into the vineyard so I want to be able to drive up to it either way

I’ve got a 1m spirit level with 2 holes in it distance apart to match top and bottom hinge of gate . Tek screw through top hole of spirit level to post set vertical bubble then screw through bottom hole , then remove leaving marks for mount holes

@FarmLearningTim

Жыл бұрын

Send me a picture mate! gday@timthompsonmedia.com.au

@yohahnboogaloo8158

Жыл бұрын

@@FarmLearningTim can't get that email address to work

@FarmLearningTim

Жыл бұрын

@@yohahnboogaloo8158 try enquiries@timthompsonmedia.com.au

That would be a nut at both ends of the string

@FarmLearningTim

Жыл бұрын

And a third one watching them both…. 😜

34 and a half inches 😂