it looks more powerful, but there's no bass... I'll give you 1 tip. in the video it appears that speakers are not in phase with each other, change the + and - wires on one of the speakers. some of these chinese amps come with the wrong lable. if i'm right you will have a big surprise, and please make a new video to show the change.

@xlopdsony5109

Жыл бұрын

Yes bro, and i think there's a hole 🕳 that needs to be covered to have more bass

Hola, muy buen proyecto, pero creo que no tenes bajos fuertes por que para que los radiadores pasivos laterales funcionen, tiene que estar sellada la parte central. Tu parlante parece que tenia una abertura por donde se ve la luz del amplificador, en el frente y abajo. Sellalo (todos los orificios incluidos por donde salen los cables) y prueba nuevamente.

@juanpabloleon6895

2 жыл бұрын

Exacto, para que de bajos fuertes tiene que quedar ermetico, yo hice uno así pero a full volumen se distorsiona porque los radiadores no dan todo el espacio para el recorrido de ambos parlantes.

nice upgrade!

Hey dude... You made it... finally ...

Nice bro but i have not enough money to buy it...... Love from india

I have this jbl which is already damage but the cover is still fine. You don't share the links for tools so that I can copy

Super

Hola Amigo, pregunto, porqué no reusas la placa de control de volumen que trae el parlante JBL. Gracias por este buen proyecto; parte 1 y 2. Espero tu respuesta.

@tinkr21

2 жыл бұрын

Hola amigo, el stock está en mono, solo está dividido en dos altavoces, no es izquierdo y derecho. así que decidí no usarlo para un estéreo, además tenía un registro de ruido.

Hi. Can you use amplifier that can be paired with other fake JBL? The benefit of this capability is you can use 2 JBL at the same time. Can you use this kind of board next time?

Using xy- p15w

Speaker brand place?

@tinkr21

2 жыл бұрын

shopee.ph/-Ready-to-ship-HK-2-inch-Harman-Kardon-Full-range-Speaker-Modified-JBL-Charge-3-Speaker-GG-Series-i.481692398.9076467665 This is where I bought it,, check in online shop in your country, Im sure its also available there

this part is the dealbreaker, you said you would be upgrading it but what about removing the amp chip then putting wires to it going to the amp. Then connecting a 3s battery setup and connecting the stock board to the 3.7 volt potential of the 3s pack also adding a switch. you made a diy speaker. not a upgrade

a mio parere hai fatto un grosso errore! hai collegato il filo che va al nuovo amplificatore sulla vecchia scheda (originale) ma lo hai collegato sbagliato hai usato il pedino numero 8 che e' l'uscita amplificata da 10W mentre dovevi collegarlo al piedino numero 4 che e' l'ingresso non amplificato per questo si sentiva male! la batteria blu puoi gettarla via non vale nulla!