Engine oil change - HONDA CX 500, GL 400 / Wymiana oleju w silniku - HONDA CX 500, GL 400

Ғылым және технология

Пікірлер: 20

  • @ganwar
    @ganwar3 жыл бұрын

    The video shows an incorrect installation of the oil filter. The correct order of the filter installation is shown here -> kzread.info/dash/bejne/l2Whx7yfj5TAaZM.html

  • @JonathanFunkhouseMonkhouse
    @JonathanFunkhouseMonkhouse2 жыл бұрын

    Watched this as I’m going to change oil on my CX for the first time this week (I haven’t had it long). Thought it didn’t look right and that spring would push the filter away from sealing it. Thanks to the other comments, I’ll put my bike back together properly.

  • @rock87garage
    @rock87garage Жыл бұрын

    Дякую)

  • @Gast-012
    @Gast-0122 жыл бұрын

    Вчера купил Honda Silver ving 500 1983 года 18000 км

  • @grigorismoraitis9299
    @grigorismoraitis92992 жыл бұрын

    Your refill was about 3 liters of oil?

  • @ganwar

    @ganwar

    2 жыл бұрын

    According to the service manual, the capacity of the oil system is 3 liters, with an oil change of 2.5 liters. I poured about 2.2 liters during my replacement.

  • @user-zw9dl4xu1b
    @user-zw9dl4xu1b3 жыл бұрын

    Хочется услышать работу двигателя

  • @ganwar

    @ganwar

    3 жыл бұрын

    Посмотрите мое видео по ремонту глушителей.

  • @gravesclayton3604
    @gravesclayton36043 жыл бұрын

    NIEPRAWIDŁOWO ZAMONTOWAŁEŚ FILTR OLEJU W GL500 I NIE BĘDZIE PRZEPŁYWAĆ OLEJU PRZEZ TWÓJ FILTR, TYLKO FILTR MOKRY! ZŁOŻYCIE TO RAZEM DO TYŁU!! PRAWIDŁOWA KOLEJNOŚĆ MONTAŻU TO: ŚRUBA - SPRĘŻYNA - PODKŁADKA - FILTR!

  • @ganwar

    @ganwar

    3 жыл бұрын

    That's right, I checked the viewer's vigilance. It took a long time for someone to notice that the assembly was incorrect. The correct installation of the oil filter is shown here. -> kzread.info/dash/bejne/l2Whx7yfj5TAaZM.html

  • @carlosgooglemaps94
    @carlosgooglemaps943 жыл бұрын

    Besides the wrong procedure of re-fitting the whole assembly something must be wrong with it, shouldn’t be that hard to remove the center bolt and also you didn’t inspect the o-rings (one for the bolt and the big one for the cover) for one dollar fifty more or les I always put new ones at every oil change, so your careless “tutorial” is not good

  • @ganwar

    @ganwar

    3 жыл бұрын

    O-rings are good, no leaks. The correct procedure for installing the filter is on another film, it is also marked in the first comment of this film. Thanks for your comments. Best regards.

  • @carlosgooglemaps94

    @carlosgooglemaps94

    3 жыл бұрын

    @@ganwar ok, I saw the video but hey couple of o-rings don’t cost much and the old ones are cooked and flat leaking or not, regards to you too mate!👍🏻

  • @ganwar

    @ganwar

    3 жыл бұрын

    In theory yes, in practice no. :)

Келесі