No video

Electro & Company EMXRON DKD Display Setup

In this video I show you how to set the units MPH/KPH and adjust the wheel circumference on the DKD Display that was installed on my Sur Ron Light Bee.
You can find the setup instructions here:
www.siaecosys.com/upfile/20201...

Пікірлер: 4

  • @hunterbates1561
    @hunterbates15612 ай бұрын

    Thank you so much for this video, this is going to help me major.

  • @josh15486
    @josh15486 Жыл бұрын

    The next screen with "PL" displayed is asking for the total reduction ratio between motor RPM and tire RPM multiplied by the number of pole pairs in your motor. So if your motor spins 6 times every time your wheel spins 1 time, and say your motor has 5 pole pairs, you would put 30 there (just an example). The number after the dash is an offset to fine tune AFAIK.

  • @gammabyte5918

    @gammabyte5918

    7 ай бұрын

    Hi, but does the offset mean? Hall Offset Angle? But why would that be useful? I read the documentation, it isn't clearer.

  • @konkhmer4life
    @konkhmer4life6 ай бұрын

    Mine would not save. After I turn off the power and then back on it went back to the factory setting. Did I do something wrong. Thanks.