Cool, I will build a set of these for myself.

If you want to add the plywood on the side of the legs, you can make the second sawhorse a couple of inches longer on the I-beam and it should be stackable.

Great job!

@ASliceofWoodWorkshop

5 жыл бұрын

Thank you. I will be getting a lot of use out of these this summer

Great video I'm needing a new set this is a great idea

@ASliceofWoodWorkshop

5 жыл бұрын

Enjoy the build and thanks for watching!

I think the concept is great. However, there are a couple of modifications that could improve it. In my opinion the bottom horizontal of the "I" Beam is overkill. Instead of running the entire width of the saw horse the bottom horizontal only needs to extend 6 -8 inches (150-180mm) near each end, to support the legs. This saves cost and weight. Also I have not placed the legs right out on the ends but moved them inboard, approx. 8"(200mm) and then cut the vertical section of the I beam shorter to allow the top horizontal to extend out each end by itself. What this does is to more easily facilitate the use of a clamp if required.

@ASliceofWoodWorkshop

4 жыл бұрын

Those are some good modifications to a basic design.

What is the height of your completed saw horse?

@paulpaid

3 жыл бұрын

About 31 and a half inches.

Americans have lidl shops? The parkside tools.

Check that first sawhorse--it is not level!

This is amazing 😂😂😂 2 by 4 😂😂😂 shitwork😂😂😂 2by4 😂😂😂