Easiest Bike Crank Bearing Removal
After dealing with several "Made in anihC" bikes and the crap bearings they use I purchased this crank bearing removal tool and it saved so much swearing on my end and wasted time.
Any questions or comments please leave them below, hope this helps out. Thanks for watching.
Пікірлер: 25
Helped so much thanks
Hi. Nice video! Please I have some questions that you might help me with. I have a Schwinn Santis and the bottom bracket looks a lot like this one. 1. Is this bike in the video also a Schwinn bike? If so would you know if this uses the same bottom bracket of a Schwinn Santis? 2. What is the internal diameter of the bottom bracket housing on the frame of the bike on the video (where you screw in the bottom bracket itself)? 3. I believe the Santis also uses a non sealed bottom bracket. If so, I would like to replace mine with a sealed one. Please which Shimano sealed bottom bracket part would you recommend? 4. Do you have the link to the tool kit that you mentioned from Amazon? Thank you very much for your time and support! Fabio
Does that last big bearing nut always turn anti clockwise ro loosen? I'm having major drama with it slipping off the teeth.
Thats the next repair to do on my E bike,Got to take the whole crank out,Replace the ball bearnings and the chain,Also check through the whole bike,Getting it cleaned up,Be fully service repaired,Just replaced the both innertubes and tires on it,Glad no longer putting up with any more punchers
@bestmoments7993
7 ай бұрын
How did you replace the paddal I need help with that
@nodafy
6 ай бұрын
Be careful with E bikes, they can get quite fiddly with the motor
I have a plain walmart schwinn ranger, the bearings were ate up in nothing left. How do I know what size to get, the model # calls for a 12 bearing but I can't seem to find one.
Thanks
Belize ya I try to make that gaged to remove crank arm
Was it easy replace all the items back into place? Do new bearings slide right in easily or do they need to be pressed in?
@mechanicvance2480
2 жыл бұрын
Everything just goes back in the order you take them out, no pressing required. The crank arms are pressed on by the crank arm bolt when you tighten it, after a ride around the block they will probably be due another tightening.
@antonio40125
Жыл бұрын
Wat is name of wrench to remove outer ring ?
@nunyatd
11 ай бұрын
@@mechanicvance2480 not if it's done correctly. You also have to make sure you use bike bearing grease in the casing where bearings are held. Put back together tight and it will work fine. That's what I have always done. Buddy forgot to mention this.
What should I do my bike has no dust cap
@cosmicmarco
Жыл бұрын
Just unscrew the bolt
Great video. Where did you find bearings to replace the old ones?
@nunyatd
11 ай бұрын
I have always took the bearing out of old mountain bikes people have thrown away. 99% of the time bearings and casing are in perfect condition I don't no what this guy does😁
Where do I buy the tool kit?
@mechanicvance2480
10 ай бұрын
Check here - www.amazon.com/gp/product/B0716NX7KC/ref=ppx_yo_dt_b_asin_title_o04_s01?ie=UTF8&psc=1
Kamao Ma o pay❤
So this socket wrench. why didn't you say the size so other people no.
Not an easy job at the end.
@mechanicvance2480
6 ай бұрын
But easier then not having the tool
Yeah... nah, looks like I'm buying a new bike instead!
Mine will not fucking come off the piece at the end.. so fucking irritated