When you Autotune just select the same line(Line#2) so you save space. Its already learning and adding-on to each Autotune you run, so there's no need to save and waste your lines when you save. Jus an FYI from other vids. Great job!!

@streetsean

4 ай бұрын

Awesome, thanks for this. It's my over cautiousness from losing other saved data along the way! Thanks again!

I believe you should select YES when asked about the trims. At least according to Fuel Moto.

@streetsean

2 жыл бұрын

I'll have to look into it, I'm planning to run the wire to have it mounted soon so I'll do more research, thanks!

@cribbsmatt

2 жыл бұрын

@@streetsean I’d link fuel moto’s instructional page but you tube blocks links. It’s on their university page in the tuning section.

@streetsean

2 жыл бұрын

@@cribbsmatt I watched it. I think I read my ProVision wrong and thought it was "Did you" and not "Do you". Thanks for pointing it out!👍

@jessearney3307

2 жыл бұрын

Absolutly have to select YES other wise it doesn't put that MAP in the tuner to flash to the ECU.

@streetsean

2 жыл бұрын

@@jessearney3307 I contacted Dynojet, it is better to select "yes" however if you select "no" it will adjust, it will just take longer to get the proper fueling.

thanks pal, great video

@streetsean

2 жыл бұрын

Thanks! Appreciate it!👍

Great video! Did u ever add more components and retune? Cnct Fuelmoto?

@streetsean

4 ай бұрын

Not yet, but I am going to retune again soon, just to make sure I got all the boxes correct.

Only prob on my 2021 is the gear selector will not work

@streetsean

2 жыл бұрын

That sucks, hopefully they can fix that under warranty?

you should have presses yes learned trim value do it again and press yes it will go even better

@streetsean

2 жыл бұрын

Yes, I did do that. It will eventually get to where it needs to but pressing yes gets you there quicker!

Thanks for the video, you did a good job explaining!!!

@streetsean

2 жыл бұрын

Thanks for watching!!!