Hey Matt, just got the unit shipped today. Thank you so much for covering any issues and doing a great job of the process

Hey, today I received my device and it will be installing next Sunday. Thank you for your tips and best regards from Poland!

i wish i could LIKE this multiple times, this has saved me so much headache. THANKS!

So far so good, just be sure to download and install any current firmware updates. Good Luck!

Thank you so much , I was having trouble with this and I couldn’t find an answer anywhere, it worked no problem, the shaker sounds better than ever

@regisdickson3142

Жыл бұрын

Hi Joseph, what did you do ? I'm having the same issue. When I hook up the amplified harness, my audio is low, but the bass is there. When I remove the amplified harness, the audio comes back, but my bass suffers. How did you get the bass to work?

Very helpful information. I also have a 2010 gt500 and can't find much info on audio upgrades on these cars. Thank you.

have the same minor hiss with my hookup... did not use the additional harness and used B cable to the subwoofer. everything works good but getting the minor hiss. thanks for exploring this.

Just the video I needed thank you

yep. having issues with mine too. made a whole video about it. safe to say i'm getting a warranty exchange. already in the process

Hey, I’ve been having the Dynavin 8 with no issues but I do need to know how to change the boot up screen. Do you have an idea on how to do that.

life saver. Thank you

I've now gone through two D8 radios. Both had no audio until (first radio) the radio was hard-rebooted. (Second radio) The volume was turned up at least 11 clicks. Obviously I can't hard-boot the radio every time I get in the car. And cranking the volume every time I get in is also a pain. Third time's a charm?

how do you control your dual climate control after installing that headunit?

Please the link to the page where they sell that radio.

I'm considering ordering one of these. How is yours working out?

How does your phone charge via usb with the cable unplugged from sync

What a car wooow! Amazing 👏

I got the unit today and I’m still experiencing the buzzing sound I followed all the instructions unplugged the amp wire that equals no sound did the amp retention unit still a buzz took the amp retention wire off still a low buzz my old car stereo did not do that it’s very frustrating

What's with the looks to be a missing piece or something on the bottom of the unit...at the 19:22 mark.

Phone charging uses power from the usb that is plugged into the back of the head unit.

Just curious, are you getting any noise in the subs with the sub harness connected?

@DeLaCruz03

2 жыл бұрын

Yeah I did but what I did was made sure when I installed it was make sure it was dead silent when I installed it in its place since the rcas aren’t really a snug fit on the back of the radio

This unit is compatible with and without sync.

I have a quick question. I recently installed the backup camera that came with this and the backup camera image is reverse. Like if I put a water bottle on the right side the camera will show it on the left side of the camera. Is there a fix for this? Thanks

@mattsautomotivechannel

Жыл бұрын

There should be a mirror image switch on the wire harness, if not there may be wire loop that can be cut. The cameras are designed this way so they can be placed on the front or back of the vehicle.

@TrapTriangle

8 ай бұрын

Dynavin setting-->android setting -display -> backcar up down mirror :)

I have the same headunit on a 13 GT. Is it possible to retrofit that front camera?

@NhoyBarangay

Жыл бұрын

Also does this Dynavin Triggers any DTC code?

Hello Matt, this video helped me fix my white noise or buzz issue and my sub woofers work perfect now and everything sounds great!! I have an observation. It seems to me that the volume on my Dynavyn 8 is the same from around 60% up to 100% and doesn't go as loud as my stock radio. Do you happen to know how to make this go as loud as my stock radio? Any thoughts on that? Thanks for the video!

@mattsautomotivechannel

Жыл бұрын

Hi Jonathan, I have not experienced this issue with my system. I recommend contacting the Dynavin tech support team, they are very good and usually get back to you within a few hours. They have always had a solution for my problems. Good luck, and have a great day!

I disconnected this horness and the audio stopped working at all. Any Idea why? This noise is really annoying. Im in touch with Dynavin support but no solution so far. Any hints will be appreciated.

@Rapt0rRed

Жыл бұрын

Did you ever resolve this issue? I'm in the same boat. I have shaker500 and get the hiss with 9000 harness. If I use the retention harness, hissing stops but audio stops working... If I unplug that 3rd connector, hissing stops again, but same thing: no audio Pretty upset seeing as it's nearly a grand for this radio.

How did you integrate the factory back up camera? Installed mine here in manila and wasnt able to make it work😩

@mattsautomotivechannel

Жыл бұрын

The back up camera on this car is an aftermarket as this car did not come with a factory one.

@dinopallasigui5284

Жыл бұрын

Would you know how to integrate the factory back up camera?🙏

@mattsautomotivechannel

Жыл бұрын

@@dinopallasigui5284 I do not know. I would contact Dynavin tech support with that question, the are very helpful and have a great turnaround time. Good luck.

How do you get the steering wheel controls to work

@mattsautomotivechannel

Жыл бұрын

Just go to "steering wheel controls" under system setting.

@MikesMafia

Жыл бұрын

@@mattsautomotivechannel my volume and skip doesn’t work and I tried to get them to work but nothing seems to do anything I got the voice control to pull up Siri in car play but that’s it

@brein03

7 ай бұрын

@@MikesMafiadid you fix the issue? If so how? My buttons aren’t working either.

is the system smooth? lag less? hows the apple play function while viewing video? any lag then?

@mattsautomotivechannel

Жыл бұрын

Just tried out video for the first time, and it looks like I have the same issue with jerky video. If I can find a solution to this problem, I will reply to this message again with an update.

@winkawak

Жыл бұрын

@@mattsautomotivechannel wow u cant catch a break lol

@winkawak

Жыл бұрын

@@mattsautomotivechannel Are u having trouble with audio volume being low?

@mattsautomotivechannel

Жыл бұрын

No volume issues since the firmware upgrade that was mentioned in part 2

@darrenwalters8313

Жыл бұрын

@@winkawak I've just installed mine last night and my audio volume seems low, did you sort yours?

What if my car doesn’t have sync it’s a 2013

@brandonv4900

2 жыл бұрын

You will not use sync at all so if you do not have it originally, your good

I like you.

By disconnecting the amp plug to remove the hiss you disconnected the subs. Dynavin is working on a solution.

@mattsautomotivechannel

2 жыл бұрын

Sounds reasonable, however door subs are still working and there was no audible difference in bass or overall sound. Just as much bass as with the original factory unit which is quite good.

@RazManOne1

2 жыл бұрын

@@mattsautomotivechannel Glad to hear yours is working. I have a 2012 shaker 500 and if i disconnect harness 3 i get no output on subs. I cannot use the retention harness either. I guess the 2012 is wired differently. It is a great upgrade option.

@warriorsmustang1784

Жыл бұрын

@@RazManOne1 I'm having the same issue. I get a buzz if I use the mid sized harness, but without it I don't have subs. Has a solution been found?

@tadair705

Жыл бұрын

@@warriorsmustang1784 Same with 2011 GT500 here. Get a buzz with or without harness but no subs without Amp plugged in.

@kpsteigstra

Жыл бұрын

Ok guys. It's been a while for you, but I just installed this in my 2010 with shaker1000. With the extra harnass the sound was just terrible, so I left it out. With the small harnass unplugged I have no subs, so it's plugged in. Ther are 2 RCA's coming from that smaller harnass. I put one into the sub jack on the HU. Gave me a big humming sound. Then I accidently touched the other RCA and it had a big influence on the humming. It needs ground I think, so I plugged it into an open jack on the HU. Humming is gone. I wonder what the second RCA is for? On the wiring diagram it's a dead end.

So no battery drain ?

@mattsautomotivechannel

Жыл бұрын

Nope, when car goes into sleep mode which takes a few minutes after shutting the car down, no more battery drain.

That's all you did was disconnect your amplifier to your subs in the front so they don't work anymore.

@mattsautomotivechannel

Жыл бұрын

Subs still work without this connector. I know, strange.

Why does everyone keep buying this head unit? It is expensive, slow and has the worst screen of any of these options! You can't see anything if it's sunny outside and God forbid you touch the screen! Am I wrong?

@TheManic.5-OH

Жыл бұрын

And hopefully no offense Matt, I'm genuinely curious why anyone would want this over something like a mekede m6 or iDoing?

@luisborja9736

4 ай бұрын

which ones would you recommend?

For the Noise you need a mass separation filter! I Fix it🥳 I think every who has a Oem Subwoofer you need that. 10-12$

Hi, I have the OEM subwoofer inside and I want it to work, but then I also get this noise, if I disconnect the plug like you did, it's gone too, but that's not the point. The noise only comes when the radio is off and you turn on the light or the ceiling light is on then the noise is back? Is there a solution? Greetings from 🇩🇪

@Crohnone

Жыл бұрын

I Fix it😁🥳 the Radio need a Filter mass separation filter!