Here is an example of DRO installation on a small lathe.
Жүктеу.....
Пікірлер: 10
@isidoromaich72268 ай бұрын
It's good to have you back! Nice project, keep it going
@eugene41542 ай бұрын
What a great job you done with your DRO, WOULD you be prepare to share your STL files for the various parts you make, I have same DRO on order at present and I could get the parts printed by my good friend
@zhadlun
2 ай бұрын
Please watch second part, if you was not ordered this dro, don’t order it!
@fynnschroer8578 ай бұрын
Nice work
@nutgone1004 ай бұрын
I bought one of these, I fitted it yesterday & it’s useless! 😢 I’ve tried everything to get it to read correctly but it’s just hopeless. I’ve heard the magnetic tape they supply isn’t great so I’ve ordered some new tape from a UK supplier. Unfortunately I bought it ages ago so I can’t send it back, hopefully the new tape will work.
@zhadlun
4 ай бұрын
It's not a magnetic tape ((( It's a devise itself. Or software on a device.
@alexmackey99224 ай бұрын
После установки многие пишут, что работает не корректно
@fynnschroer8578 ай бұрын
Kannst du die proxxon mf70 fräse empfehlen, Oder sollte man die Finger weg lassen?
@zhadlun
8 ай бұрын
Depends on a task, but I would go for at least FF230
Пікірлер: 10
It's good to have you back! Nice project, keep it going
What a great job you done with your DRO, WOULD you be prepare to share your STL files for the various parts you make, I have same DRO on order at present and I could get the parts printed by my good friend
@zhadlun
2 ай бұрын
Please watch second part, if you was not ordered this dro, don’t order it!
Nice work
I bought one of these, I fitted it yesterday & it’s useless! 😢 I’ve tried everything to get it to read correctly but it’s just hopeless. I’ve heard the magnetic tape they supply isn’t great so I’ve ordered some new tape from a UK supplier. Unfortunately I bought it ages ago so I can’t send it back, hopefully the new tape will work.
@zhadlun
4 ай бұрын
It's not a magnetic tape ((( It's a devise itself. Or software on a device.
После установки многие пишут, что работает не корректно
Kannst du die proxxon mf70 fräse empfehlen, Oder sollte man die Finger weg lassen?
@zhadlun
8 ай бұрын
Depends on a task, but I would go for at least FF230
15:51 the m2 sensor screw?