In this video I explain how I want to do the redesign to get the table saw lift mechanism more stable. I mount some some more bracings and cross beams and mount the new hgr15 linear rails and the lead screw.
In the end I give it all a test :)
If you want to check out the 3D-model and the cut lists, check out this videos page on my website (first edition):
willysgaragenorway.no/2021/02/...
⬇ DIY Table Saw build series:
#1: • DIY Table Saw #1 - Des...
#2: • DIY Table Saw #2 - 1st...
#3: • DIY Table Saw #3 - Lif...
#4: • DIY Table Saw #4 - Cab...
#5: • DIY Table Saw #5 - To-...
#6: TBA
#7 ??
Want to give me a coffee?:
🍹 www.paypal.me/WillysGarageNorway
🍹 www.buymeacoffee.com/willysga...
Willys Garage Norway products link sheet (BETA-Version):
🔥 bit.ly/2PL9Nxm
Timestamps:
00:00 Introduction
00:36 HGR15 Linear Rails
00:59 Dismantling the old Lift Mechanism
01:31 Mounting the Bearing Blocks #2
02:23 Mounting the Lead Screw
03:02 Explanation
03:43 Showing the Redesign
04:08 The Man with the Plan
05:03 Figuring out the measurements
07:25 Mounting the HGR15 Rails
08:25 The linear rails are installed
08:37 Aluminium for bracing
09:23 Mounting the aluminium
10:08 Aluminium Cross Beam
11:08 Mounting the motor plate
11:47 Showing of the redesign
12:28 Outro
Community:
Website: goo.gl/9wZcs1
Instagram: goo.gl/1TnxKW
Facebook: goo.gl/H7L72E
Patreon: goo.gl/5pm5qs
Twitter: goo.gl/fzWWcA
Music:
www.epidemicsound.com/
#DIYTableSaw #TableSaw #Fusion360