Diy simple and easy metal detector | diy metal detector using lm386
Ғылым және технология
hi friends
This a diy metal detector using lm386 amplifier ic.The LM386 is an integrated circuit containing a low-voltage audio power amplifier.it is suitable for battery-powered devices such as radios, guitar amplifiers, and hobby electronics projects.
more videos:
/ @electorr
----------------------------------
telegram:
t.me/electorr
instagram:
/ electorr86
-----------------------------------
Song: NIVIRO - Flares [NCS Release]
Music provided by NoCopyrightSounds
Free Download/Stream: ncs.io/Flares
Watch: • NIVIRO - Flares | Hous...
-----------------------------------
#diy #viral #electronics #diyprojects #electrical
Пікірлер: 7
Thanks for your valuable project. I have rebuilt the circuit but it would not go with the BC945 maybe because ive damaged it with heat from soldering . I replaced the BC945 with a BC547 transistor and it worked with constant loud buzzer. The coil was sensitive at 40 cm but the buzzer sound variation is difficult to discern. I can tell the buzzer shows some variability but it needs a careful ear to distinguish. I dont know if anything can be added to make the sound variability easier to distinguish. Note the circuit is exactly the same to yours but i used an NPN BC 547 transistor instead of the bc945 transistor with 0.4 mm copper wire 52 turns and volts battery . I tried adding B10k potentiometer to control the buzzer volume, but it was not very helpful. Any advice? Many thanks to your useful videos.
@Electorr
21 күн бұрын
Hi brother Lower the voltage until noise reduction. Mine worked in 6 - 7 volt. And your coil is ok, I hope it works for you.
@hodhod.data.analysis
21 күн бұрын
@@Electorr Thank you so much.
عالیه❤
@Electorr
Ай бұрын
سپاس
Will this circuit work, i tried many circuits available on internet. They are not working and this is my topic for mini project. Will it work? Please reply Sir 🙏
@Electorr
Ай бұрын
All my projects work, but you should build them exactly what I built. Goodluck