DIY Install: DNA Projector Headlights Toyota FJ Cruiser (07-13) Sequential w/ LED Bar & Black/Smoked
Автокөліктер мен көлік құралдары
Order here: shop.redline360.com/products/...
All DNA Motoring lights on Redline360 are sold as a pair. Each order comes with the driver side and passanger side.
Fitment Information
Toyota Fj Cruiser (2007, 2008, 2009, 2010, 2011, 2012, 2013)
Specs & Features
Sold as a pair
H4 9003 High / Low Beam
LED Sequential Chasing Turn Signal
White LED Running Light Strip (Requires Wiring to Existing Lights)
Product Description
DNA Motoring Headlights are designed to update the look of your vehicle with a stylish and new set of lights to set you apart from everyone else. Designed to DOT specifications and made to be a direct replacement for the factory lights (some minor wiring may be required).
Manufacturer Warranty
Every set of DNA Motoring lights come with a standard 30 day manufacturer warranty.
Redline360 sells only genuine and authentic DNA Motoring products.
Пікірлер: 18
Order here: shop.redline360.com/products/dna-projector-headlights-toyota-fj-cruiser-07-13-w-led-bar-and-black-housing
@DLLA888
Жыл бұрын
2017 FJ Can it be installed?
How to wire the Halo Lights. Strip the ends of the the two sets of black and white wires. Twist the blacks together (these are the grounds) and the whites together (These are the leads). Unplug the connector from the back of the headlight. It has 3 wires and 3 connections made to the bulb. You want to tap the horizontal connector. This is the one that has the 2 vertical connectors one on each side. On the drivers side this is a red/yellow wire and on the passenger side I'm not sure of the color but again it is the wire feeding the horizontal part of the connector. Unplug the lights get a voltmeter on DC Voltage 20 Volts and turn the truck on. When you put the red wire into the horizontal connector and the black to ground you will see 12v or more. This is the wire you want to tap. Use a tap where you place the existing wire through it and the 2 whites that you twisted together and snap it closed. Do this on each side of the truck but keep in mind the existing wire on the passengers side is thicker so you will use two different size connectors. Then connect the two blacks together on each side and connect them to a wire long enough to reach a ground point. I ran mine to the terminal on the side wall just in front of the under the hood fuse box. It takes time but make good connections and it should work when you turn the truck on.
@MrFuriousgeorge55
Жыл бұрын
This is helpful as the video doesn't really explain this. Any chance of a video or pictures?
@Maneras03
10 ай бұрын
You should do a video bro I got lost halfway 🙏
How do you aim these light my high beams are not even visible on the street.
Has anyone had the halo part of the headlight stop working?
The most important part, how to connect the wires (splicing), it doesn't show. BS video
What are the assemblies with the turn signals called, and how much are they worth?
But how did you wire up the halos ? Poor quality instructions
@sparkmister13
Жыл бұрын
see my comment
How did you wire the halos? 10:40
@sparkmister13
Жыл бұрын
see my comment
How are the halos wired??
@sparkmister13
Жыл бұрын
see my comment
Music is dumb, instructions unclear.