"Working process"
1. Material cutting (mm)
Main body 10 x 85 x 300 12 sheets (sugi)
Bottom plate 12 x 150 x 340 1 sheet (plywood)
Lid 10 x 25 x 360 2 sheets (sugi)
10 x 25 x 170 2 sheets (sugi)
Bag stopper
10 x 10 x 335 2 (sugi)
10 x 10 x 120 2 (sugi)
* Cut the lid off (cut 45 degrees) and cut it off.
Save the cut-off triangular scraps
Tool HIKOKI FC7FSB slide circular saw
amzn.to/3bH2ks5
2. Plate peeling (joining)
Make a four-sided board of the main body by sticking 10 x 85 x 300 boards side by side with a bond and a clamp with 4 pieces, 4 pieces, 2 pieces, and 2 pieces.
* It is better to hold down the material with a long scrap so that it does not rise.
Tool Kakuri Hatagane 900mm
Https://amzn.to/3bNSl4B
Kakuri Ratchet Bar Clamp 300mm
Https://amzn.to/2RKec1D
3. Assembling the lid and stopper
・ Connect the lid with masking tape, attach it with a bond, and fix it with a clamp.
・ The stopper is fixed with a bond and a nail.
Tools Daiso Clamp & Hammer
Kakushi nail amzn.to/2XHyGuD
Quick-drying bond
4. Assembly of the main body
・ Fix the four stripped plates with a bond and a nail while fixing them with a corner clamp.
・ When 4 sides are completed, attach a bond to the bottom plate, insert it, and fix it with a nail.
・ Fix the triangular scraps that were cut off when the clip was cut off at the four internal angles with bonds.
・ Similarly, attach the scraps to the lid with a bond so that you can get hooked on it.
Tool Daiso Hammer
Kakushi nail amzn.to/2XHyGuD
Quick-drying bond
5. Painting
The cedar board used as the material was left over from the previous wall production, so it has already been painted, and this time only the unpainted parts are painted.
Apply with a waste cloth, dry for 30 minutes, and brush with a brush.
Paint BRIWAX Tudor Oak
Https://amzn.to/3oMkRXX
Tool Daiso shoe shine brush
【Photographic Equipment】
◻️ Camera, lens
SONY α7c ILCE-7C
amzn.to/3nN3AfC
Tamron 20mm F / 2.8 Di III OSD M1: 2 (Model F050)
amzn.to/3nOBOQ5
◻️ Editing software
Lumafusion
◻️ BGM
epidemic sound
Mirror / Ciaran Delany