DIY, How to make your own Flagstones using the AUTUMN Flagstone Mold for Concrete
Тәжірибелік нұсқаулар және стиль
Detailed step by step guide on how to make your own concrete pavers using the AUTUMN concrete flagstone molds. Did the molds hold up? Watch and see.
Amazon associate link: amzn.to/3Gs48S5
Пікірлер: 14
use a reciprocating saw and attach a blade to the board. Vibrate it for 30 seconds and done.
Brush diesel on forms and it will work way better than Pam. Nice work.
Great video! How big were the bags of mix (Quikrete Crack Resistant) that you used for six molds?
@Killobyte
Жыл бұрын
The bags were 50lbs and there was some left in the bag after a batch. It's been awhile but I think it is around 40lbs of the Quikrete crack resistant per batch.
Thanks for the video. I have these molds, but some cracked on me. Too much or too little water? Any advice
@Killobyte
2 жыл бұрын
Sorry to hear that. It is normally because of too much water. Too fast of drying time will also weaken them.
How bags of quickcrete did it take for an area sized shown at the end?
@Killobyte
2 жыл бұрын
Total quickcrete used was about 380 pounds.
Nice. If you were to fill a mold with dry concrete would that roughly be the amount of concrete you need for that mold? Trying not to waste concrete here.
@Killobyte
Жыл бұрын
I believe it should be, but I've not tested it.
@brandonmonroe7050
Жыл бұрын
@Killobyte thank you for responding I would think it would be the same amount almost exactly plus adding water would make it a little more than enough
lol, nope i have these exact molds, they come from Kyiv Ukraine
@tikakahn2521
Жыл бұрын
Used to come from Kyiv, now ships from US, got mine in a day-n-half after I ordered from DC. Total cost to the manufacturer for all 6 pieces could NOT be more than 6 bucks (given the material/quality of the mold). an 1100% markup is what doesn't fit well with me about this product.