A tip for removing the container. Pour hot hot water over the bottom and it comes off pretty easily without damaging your mold. That turned out quite well.

excelentes trabajos, muchas gracias.

Amazing!!!

Håber at se mere fra dig i beton. Fedt lavet - virkelig FLOT. Nice Work!

I’ll be working on that project today!!!! Thank you so much for sharing your knowledge. I am thankful for you.

@DIYSupply

3 жыл бұрын

Hey Nancy, that sounds awesome! Thanks to you, for leaving your thoughts :) Good luck with the project!

awesome

Genial. Parabéns.

Overholder dette evt. krav ift. 60364 og/eller 1082?

Where’d you get the socket and cord from?

With the plastic mold iT is really shinny

what paint should i put on it ...oil paint or matte ? thxxx ☺

Genial 👏

Did yo check for electricity?

@DIYSupply

4 жыл бұрын

Yes

can u give the quatity of concrete used

@DIYSupply

Жыл бұрын

Hey Jessy I used the cheapest I could find, premixed, just added water.

Wait for 2 days? Why not for 1 days?

@roxans557

3 жыл бұрын

I'm not an expert, but probably to allow enough time for the concrete to cure. If it's not allowed enough time to cure, the concrete will be weaker