Nice job but plenty of good comments for others to follow to avoid your mistakes. Should have gravel at bottom of hole and add some concrete before sticking your center rebar. You don’t want rebar in the dirt cause it will rust. Should be fully encased in cement. Definitely don’t pay extra for dry set concrete if you’re going to mix it anyway, plus it needed more water. A couple of support rebars would be good. You have to poke the cement with the rebar as you add cement. What you did at the end did nothing because you didn’t get more than a 1/4 of the way through the tube. The concrete further down is full of air pockets which means your rebar will rust as water seeps in. Other than that, you’re good.

@user-pd5zi5zt5g

2 ай бұрын

Thanks to all , the video and the comments helped me alot with my first project of laying a 10×8 concrete slab

@jjshow8572

Ай бұрын

Bruh it don’t even rain in his area

@CharlaLester

Ай бұрын

good

Hey y’all this is a DYI project calm down. Thanks for sharing. Love that property line stonewall.

You just wanted to show off that beautiful wall. You can't fool a fool

Wow! Good lookin dude, good lookin footings!

This was SO HELPFUL! Thank you! I have no idea what most of this stuff is but I will be able to google all the names of the stuff you used to help me get a better understanding. On to the next video!

@desireereyes-calderon3486

Жыл бұрын

Hi

Since you used a wheelbarrow to mix the concreate you could have just used regular bagged concreate (which is less expensive) It's much easier to work with and you have more time more time to work with it . "Regular" Concrete mix (of the correct grade) when used in footings/foundations, will also provided a more structurally stronger result. Like others have pointed out, you really need to spend more time making sure there where no air gapes in the mix by the use of a piece of steel rod etc, and then "tramp" it down more at the half filled point. But hey! it was your first go and good on-ya for giving it a go!

Just my thoughts. I would have drawn the strings and keep them during the process. So you get the 90 angel on the middle one and also get the ancar bolts in line.

There are a lot of videos against "wet setting" anchor bolts. In this case, the concrete mix is too dry and did not flow to close around the anchor bolt. The resulting void will fill with water and may lead to premature failure of the concrete.

@johnraviella6561

10 ай бұрын

Says who. Show us engineering references please

@mrluckybreak

10 ай бұрын

@@johnraviella6561 kzread.info/dash/bejne/eXyTyNadoKaTYso.html

@seanbrotherton542

21 күн бұрын

​@johnraviella6561 if you work with this concrete on a regular basis you don't need an engineer to tell you. The correct method is pouring the mix into the form and then add water. It settles and closes voids. The concrete begins to harden in less than 10 mins and is unworkable in 15. At 20 mins its over. If you aren't done by then you're screwed. The instructions on the bag says pour the mix in the form or hole. They make the stuff so what do they know anyway

Awesome! Looking forward to your other videos!!

Yes...it looks a bit dry and he should have tamped down the aggregate (gravel in the mix) with a 2x4 instead of the rebar, then smooth over the top

You need more water in the concrete mix.

@johnasdoe3699

2 жыл бұрын

I weanted to comment the same - concrete mix is some too dry.

@jdjeep46

2 жыл бұрын

Not true, his mix was perfect.

@johnasdoe3699

2 жыл бұрын

@@jdjeep46 OK

@tim-hill

2 жыл бұрын

Yep. Too dry. It's as if he couldn't read the amount to use per bag on the side of the packaging.

@Nychole3080

2 жыл бұрын

He did. He stated he actually used slightly more water than what the bag instructed.

Can’t wait for the continuation of this project you started. Next video please🙏

@HouseholdHowTo

3 жыл бұрын

Thanks! Working hard on the next portion.

Good. Video. Thank you! However, he is building on what looks like very level land. If you have a slope, you may need a transit and builders level to ensure all footings are the same height. This will save aggravation later on in your build

I like this vid, best I seen

Nice stone wall

Good video! Did you also build your stone and concrete fence?

And you pray that no one will step accidentally over the anchor bolt :D But in general i would add more water to the mixture. It looks too dry. Additionally using a longer anchor bold seems to be better idea which you can easily cut with the grinder if its too long.

Prefectionist.

Did city require an inspection on the footings before you poured concrete?

thanks for the vid, did you end up needing 2 bags per footing? also, is your frost line only at 6" you cut your tubes into thirds, so your holes only needed to be 18" deep?

@HouseholdHowTo

3 жыл бұрын

Each tube needed about 3 bags of the 50lb stuff. You're correct, our frost line is only 6" here. One of the few benefits of living in the desert I guess!

Good ole El Paso... Can always tell by those walls... Peace

So what area of El Paso is this project being done at?

I def would make the concrete a little wetter than that and I would not wait until the end to vibrate to ensure no voids are left. You would be very surprised at how easy it is to have voids in the structure caused by trapped air if you were to break apart the pier. I'm sure this will do the job for a backyard setting but if structural strength is important, I would def take these steps.

THANK YOU

Does the concrete need to stick above the ground?

With concrete you want the wetter the better they say . But on the contrary you don't want to wash the Portland cement for the aggregate so don't make soup make pudding ... also if you were going to mix it in a wheelbarrow should have used regular concrete....

What are the measurements of your post?? Also away from ur wall??

How did you build that wall?

How did you measure the height of them to each other though? I need to set 8 of them for a 18 x 20 pergola.

@HouseholdHowTo

3 жыл бұрын

I ran a tight string from the edge of one to the edge of the others and made sure the string was level.

@seansmith8786

3 жыл бұрын

You can purchase a little level that will hook to a string line. Look up 'String Level'. They're very inexpensive.

Great 👍 job!! How much water do you poured on one bag of concrete?

@HouseholdHowTo

3 жыл бұрын

It was slightly more than what was stated on the bag (around 2.5L).

Could this method be used as a mount for a freestanding pergola or pergola kit?

You sunk the anchors pretty deep....did you leave enough anchor above the concrete to attach it to your joists...looks like you only have about 2" to play with....maybe I'm not seeing it clearly....

@drewnorth8985

2 жыл бұрын

You use a fitting. 2 inches is more than enough.

You need to add more water to improve workability.

How were you able to get away with that wall? I live on an island in Georgia on the main road coming on to the island. You think i could get away with this? Without pulling a permit?

What do you need footings for Don’t you are already have a pair of feet

I have a deck that I am going to put my pergola on. Can I put my 4x4x6 posts inside of the cylinder footings?

@makaylalocklear5487

2 жыл бұрын

I have seen people use flower pots and home depo buckets but I wanted something slimmer. If I need to use those ideas instead because it is safer and sturdier I will.

@HouseholdHowTo

2 жыл бұрын

Would the footings be physically attached to the deck in any way?

16 inches.... is this in El Paso?

How long did you waited for it to dry before putting up the pergola?

@HouseholdHowTo

Ай бұрын

I let it dry for a week before I started the pergola

At minute 4:50 “that’s not quite right” 🤣

You in El Paso?

the concrete mix is too hard plus you should have poked it with the rebar half way through, now you have concrete with hollow holes in it

Hi, thanks for the video. It really helped me to make my plan. When u dig first for the tube it’s bigger than the hole and filled additional space with dirt - is it fine if it’s left like that asking because mine looks loose. Thx

@HouseholdHowTo

Жыл бұрын

You'll just want it to be stable enough so that it does not wiggle around while you're filling it up with concrete.

I thought you had to add rebar in the cement for structural support?

@HouseholdHowTo

2 жыл бұрын

I would certainly consider adding rebar if these were supporting a more substantial structure, or if the piers were above grade. Since these are buried with very stable and dense soil conditions, I decided against it. Thanks for the suggestion!

@tim-hill

2 жыл бұрын

Agreed. Rebar would also help the concrete stay together over time.

@-ssch

Жыл бұрын

@@HouseholdHowTo if I want to add rebar. I just need to stick couple of two foot bars into the pillar is fine ?

@HouseholdHowTo

Жыл бұрын

@@-ssch Sure, you just want to make sure the rebar is fully encapsulated within the concrete. Any rebar poking out the top or bottom will be at risk for corrosion and may weaken the footing.

Where are you located?

Why not mix the concrete in a 5 gallon bucket? Seems easier than a wheelbarrow???

Hi what were your dimensions

4:00 I guess that makes me a pro 🤷🏿‍♂️

how deep were ur footers and how big was ur sonotube?

@HouseholdHowTo

2 жыл бұрын

12 inches in diameter and a little over 16 inches deep.

Do you live in El Paso?

@HouseholdHowTo

3 жыл бұрын

I do. Rock walls give it away?

@fishsticks105

3 жыл бұрын

Yes, I was wondering the same thing. I wonder if all footings need to be made at 16” in EP?

That concrete was dry af you shouldn't need a hammer to drive in your anchor bolt or have to back fill the hole

@GLMracing

2 жыл бұрын

that was funny him poking holes then covering the holes with half dry concrete,,, boom,, instant air pockets

Where vid 2

That’s not the way to work concrete

That water to mix ratio was way off. You practically have gravel underneath of the smooth top. Then again, it could be just the camera making it look that way.

@charlesa3374

3 жыл бұрын

Which makes the footing useless.....

what was your total cost?

Facing the wheelbarrow the other way would have made shovelling the concrete much easier.

This is why you get someone that knows what they’re doing to do the job for you.

Duuuude that concrete is WAY too dry, you didn't rod the mix as you were filling the tube (to eliminate any voids), and that anchor bolt no doubt has voids around it since you hammered it into dry mix and barely filled the open slot it left! I hope it lasts for you.

all that effort and you didn't even make sure the anchor bolt was perpendicular. can you say "crooked"?

@GLMracing

2 жыл бұрын

so much for measuring

One gallon of water per 80lbs bag.so every one knows

good video but I pour more milk on my breakfast than u put in that barrow fist time lol

Do not have rebar sitting on dirt. It will rust. It can sit on gravel. If you make a large circular area in the middle of the wheel barrel and pour water in that is the best way to work concrete. It is also advised to secure sonic tubes. Some people build a little frame around it and stake it if it is a shallow pour. Remember, concrete for posts drys very fast.

More water in the mix, no reason to use fast setting mix.,You have more time to work to be sure there are voids inside the sonotube with normal setting concrete.

Bro concrete is way to dry

I have done very similar with woodglut designs.

Ok…there is so many options here,it’s a pergola

You need more water!

So you go out and buy the more expensive post Crete dry mix then mix it? ??? WTF is the point of spending the extra cash. Also hammering your L bolt into this half wet mix means your bolt is now more likely than not sitting in a void inside the concrete no matter how much you think you “back fill” it. So is probably as much use a pork chop at a Bar-mitzvah.

i have seen a lot of videos from experts, and something tells me this concrete mix is too dry

Your concrete mix is dry it’s gonna crumble

More water 💦

Bro ain’t concolidate also concrete too dry need a slump of 4 to be at its best quality not too much water but not too dry

That looks way too dry

Sorry but your mix is to dry

Way to dry

Wtf was thag

Another amateur showing people the wrong way to do home improvement projects

Amateur !

nice cause that steucture isnt going to fly away in the wind 👍

Absolutely no reason and counterproductive to use the quickset stuff if you're going to pre-mix it. Too dry also.