DIY Bounce House Blower Vacuum System (Part 2)
Тәжірибелік нұсқаулар және стиль
Recycling a bounce house blower into a DIY dust collection system has its suck-sesses and failures. Join me for part 2 of this workshop hack where I start putting all the pieces (of pipe) together.
00:00 Intro/Recap
00:59 Weak @$$ Elbows
01:43 Ye Ol' Dustbag
02:09 GFCI Removal
02:43 Installing the New System
05:53 Results
06:30 Conclusion
#toystotools #DIY #woodshop
🔔 Subscribe for more woodworking how to videos like this:
/ @beardedowlstudio
Пікірлер: 3
This was very well produced and I'm surprised you haven't gathered more views.
I came across this video while I was searching for a way to recover refrigerant from the HVAC unit. I assume KZread knew at one point I was focused on finding a way to build my own dust collection system. Not bad video, I actually have the exact same blower from a inflatable that I found on the side of the road and also I have the exact same dust collector accessory kit from Harbor freight that I purchased on marketplace a little while back and I’ve been trying to figure out a way to use it. I might have to give this a shot I’ll let you know how it goes until then you got a new subscriber. Ready for part 3.
@beardedowlstudio
2 жыл бұрын
Hey thanks! KZread is good at that sort of thing haha. The real test will be how much suction I’ll get at the table saw in part 3. Even if it isn’t great, this is a good stop gap until I get a real system. Thanks so much for watching!