Discussing the twine system in a 430/435 John Deere round baler
We discuss how the twine system on a 430 John Deere baler works and what to look for when having issues. How to bleed the twine pump and the overall differences between a 430 and 435 baler. I also explain how to engage the twine arm without a bale in the baler to check the twine system. The reason I lock the tailgate to do so is to put the slack in the belts to the rear of the baler and not at the front where the twine arm could potentially get caught and bent in the belts. Hope this info is helpful.
Пікірлер: 17
What an amazing guy we were broke down in Ont canada with our 430 jd baler he called personally and led us to the fix Thank you so much Brian
@BrianCraig870
18 күн бұрын
@@KenPrince-v9o thank you
Thanks for your insight on the 430. We are running one in Arkansas and she is holding tight!
This is a great video. Thank you for sharing. I have a JD 435 and the twine arm will not engage automatically. I have to manually engage the twine arm by pulling the outside lever no matter the bale size. I’ve been trying to figure out how to get it to work properly for a while with no luck. Do you know what could prevent it from tying automatically? Following your video instructions, I can now tell that the manifold plunger is not lifted up but I’m not sure what to adjust to make it rise.
@BrianCraig870
11 ай бұрын
Can you PM me in messenger. Brian Craig
@jacobfischer5728
2 ай бұрын
@@BrianCraig870 can you dm me somehow to discuss a 435 kinda lost on it
@BrianCraig870
Ай бұрын
@@jacobfischer5728I’m not sure how to DM you
How much air would you suggest blowing in? I have a 530, almost exact same twine system. The pump ram low on fluid friday night, and now the twine arm won't move. Anyone have any suggestions? I think I've narrowed it down to either the pump or the needle valve
@BrianCraig870
10 күн бұрын
@@beeffarmer8576 a good shot of air will usually get it going as long as the pump is good.
@beeffarmer8576
10 күн бұрын
Ill try that. Thanks for the advice! @@BrianCraig870
@beeffarmer8576
9 күн бұрын
@@BrianCraig870 tried air and no luck. At this point i think the pump may be shot.
@BrianCraig870
8 күн бұрын
@@beeffarmer8576 that is a good possibility. I’ve installed pumps from an 80’s Chevy 350 engine. Swap the relief out of the original one and put it in the new one.
We have JD 430 baler that randomly locks up during baling and shuts off tractor. You can dump bale and start over normally, but today it would get about 4 foot bale and lock up and shut tractor off. Have you had any experience with this issue?
@BrianCraig870
7 ай бұрын
Is the tailgate opening causing the baler to stop baling?
What kind of fluid goes in a 430 John Deere baler?
@BrianCraig870
Ай бұрын
I use hydraulic fluid in my system
Can you PM me in messenger and I’ll try to diagnose it for you. Brian Craig.