Informative video. بہت خوب

i well understand your video. Thank u very much our engineer...

Thanks for the lesson. Great

Great 💪🏿 A million thanks

Very short and clear Thank alot

Excellent explanation thank you

Good lesson I well understand

Nice video

Very helpful video and bhaijan you are looking beautiful

Ld formula not correct...check the formula from clause 26.2.1 IS code 456:2000 . (Dia x 0.87 x fy / 4 x Tbd)

Thank you our engineer

you are so smart thank uou

Good work

Could you make a video explaining where (how far apart) the pillars or the columns would go on a three-story house that’s 5 m x 5 m. Thank you 🙏

Thank you Sir 🙏🙏

Sir u r pronounce is Soo good ..

Thank you 😊

Thanks engineer

Great videos my brother .... in Longitudinal rodes (vertical bars) do the development beam connect to ..... does it connect on the bar next to beam or it connect on the middle bar or it connect on the outer opp bar (assuming a column is a 8-point bars )? 🤣🤣

Sir Why lapping length not provided if reinforcement dia more than or equal to 36 mm

Thanks sir

Sir u r pronounce is special

Its good

Aoa sir your videos ar usmd ful sir kindly tell us about coĺumn nd beam in basement 35*40

How do you calculate Tbd ?

Explanation is good laping length how many ft

But you told us in the formal video that dl= 0.42D where D is depths of beam but now you said is 0.87y/Tbd

For different grade of concrete, we have different bond stress, Tau bd

Sport bar means?

Sir 0.87 but is456 is not be used

What is bond stress

50d lapping length provide in all cases?

@tiinofficial7575

4 жыл бұрын

50??

I have some doubts, As we practice on site as per the drawings... The development length is the total length of L shaped bar, start from the face of the column and beam, but you told it's only the bent portion of the rebar in side the column... Please clearfy.. And it's not a constant value it varies with the grade concrete.... In general we use 50 d... But you told 18 d???? Please

@MAnas-el6cd

Жыл бұрын

Development length is the bent L portion inside the col.

In development length formula what is the constant 0.87.

@sailajajittuka2902

4 жыл бұрын

0.87fy is design stress of steel ie., 1/1.15 (partial safety factor) = 0.87

How many inch for lapping lenght

What is is456

Assalamualaikum sir ap urdu ma b video bnaya kren kindly

@jakiasultana5088

3 жыл бұрын

Also in Bangla. From Bangladesh.

16 x12 =192 mm =8 inches which is less than 12 inches..I guess something is missing here...or u have not calculated some factor. Thnx

@josephgogo2545

11 ай бұрын

50d

very helpful but sir instead of writting plizz used computerised spellng

loping length draw only calculation show's to draw

Writting font is too small

Why good by ? Should Allah Hafiz. From Bangladesh.

45d from IS:456 2000. CLAUSE PLEASE

Other ...atherrr

D0. 87fy/4 tbd

Not satisfied