The only way mine would get to 60 mph is of i drove it off the side of the empire state building. Its really happy around 45 - 47 mph. Mine is bone stock , the only thing different from when it was built is i had to replace the engine and went with a turbo charged one. It really starts so much easier but the whistling of the turbo sounds cool it gets on your nerves after a while.

@hummerguy

2 жыл бұрын

Same with mines, I have the c turbo

I always appreciate the deuce videos. I'm glad I have the 395's compared to the stock NDT tires. Better on wet and snowy roads as well as off-road, but the speed is much better. I usually like to cruise around 55 mph, which has the engine rpms around 2100-2200. I've topped out at 70 mph once, but the engine was screaming. Doing that for short periods of time doesn't hurt it. Doing it for long periods of time will eventually throw a bearing or a rod. It can also cause overheating issues as far as exhaust temps go. I drove from MI to NE, 1200 miles that way at full bore, 56 mph at 2600 rpm, this was my old deuce with the 9-20 NDT tires. She overheated and less than a week later the head gasket blew and it melted a piston. For whatever size tires one runs on their deuce, the multi-fuel engines like to stay around that 1900-2200 rpm mark.

I never got above 45 Miles an hour. Even though I tried that's all it would do except on down hill with a good wind it would go 55 the motor would cut out at 45 but you can hold the clutch in and get a little extra speed. It was terrible on hills as it would slow down to 35 miles and hour . On the interstate it's offensive driving only.

Its huge, slow, and not really practical but I still would like to have one.

Deuces are designed to go slow so everyone can get a better look at all that glory! Thanks for bringing back the Deuce vids! Another thing to consider with these trucks is the braking system. Being able to stop is a good thing, and the higher the speed, the harder it is to stop. I'll keep mine under 50 and enjoy the ride.

The Technical Manual answer is that an M35A2 maximum speed is 56 MPH, and the cruise speed is 45MPH. In stock configuration as issued, a Deuce cannot achieve 56MPH on flat ground. "Stock Configuration" is the key word. If you put an extra high 5th gear in the Spicer 3053 Transmission, you can do it. Or if you do a "Fuel Density Compensator" (FDC) bypass then you might be able, depending on your fuel system's condition. And you should do an FDC bypass, it was an Army Mandated service item starting around 1997. FDCs wear out, are not serviceable items, and can leak, mix fuel and engine oil, which will destroy the bearing surfaces in your engine over time. If you bypass the FDC don't think that because you can drive 56 MPH that you can safely do so. A pump old enough to need the bypass is not 100%, will have other sealing and lubrication issues, and can be damaged from that. It is also possible to buy a "G" model injection pump, which lacks an FDC entirely. That has happened to me. Post FDC-bypass the governor fork or rod in the injection pump broke, and I purchased a new G model pump. I can now do 55MPH on a slight incline, without putting the pedal to the floor...but I mostly keep it around 50 MPH if on a highway, and 45 MPH otherwise.

I would think it would be how fast it isn't rather than how fast it is LOL.

I got a good look at a bobbed duce and a half last summer at the Menards parking lot. Looked great and the owner was very happy with it. He used it as his weekend project Truck.

Looking into your videos again 'cause I'm going to look at a m185A3 tomorrow!

@deuceandguns

2 жыл бұрын

Thanks for stopping by and good luck on that M185!

@jericho9510

2 жыл бұрын

@@deuceandguns thanks again! Have a good day.

@jericho9510

2 жыл бұрын

@@deuceandguns it didn't happen. The vehicle meat every walk away point you made. Oh well. Ill just save up and try for a m923a2.

@deuceandguns

2 жыл бұрын

Sorry to hear that it fell through but at least you didn't buy someone else's failed project and money pit.

@jericho9510

2 жыл бұрын

@@deuceandguns on the bright side, I just got my CDL permit and will be go I g to road master soon. But thanks for the videos!

My '71 deuce with 11 20 Goodyear G177s maxed at 60 via GPS when I drove it home. It was down grade with a tail wind and the clutch in and it was for .75 seconds but it did get there.

The M35A2 Deuce and a Half. 0 to 60 in 49.61 seconds!

Great content. I was wondering what the acceleration speed of a stock m35a2. Thanks for sharing.

Very cool. If they're that anemic empty, I'd hate to be behind one (well I would even empty) if it was loaded with 10,000lbs. Thanks for sharing.

We are a deuce lover.

Can you do a Video on the Flex pipe on the exhaust pipe to the stack. Thanks God Bless..

Very interesting! I love the M35a2s. Have you tried any other fuels other than diesel #2? I have heard you can even use heating oil for fuel, as long as it has been filtered.

@toddk1377

2 жыл бұрын

You can. Has to be thin like diesel too if you want the in tank pump to last. I mix wmo with gas all the time. Usually about 15 gallons of gas to 35 gallons of wmo. Runs just fine.

@googleuser3760

2 жыл бұрын

@@toddk1377 What is wmo?

@IG10705

2 жыл бұрын

@@googleuser3760 waste motor oil

@googleuser3760

2 жыл бұрын

@@IG10705 oh thanks.

@IG10705

2 жыл бұрын

@@googleuser3760 you're welcome

Lol i keep having to remind myself that my 1st gen Powerstroke has more horsepower then your duece does. Thanks for sharing.

@deuceandguns

2 жыл бұрын

Yep, my 97 F-250 7.3 runs circles around the Deuce.

@toddk1377

2 жыл бұрын

Yeah, the engines in the deuce only put about 130-136 hp and that is with the turbo. When rubber meets the road, due to the transmission and axle gear ratios, the deuce has some incredible pulling power, at least within the first 3 gears in high range and all 5 gears in low range.

I drove a 5 ton with 2 deuce and half trucks fallowing along from barsto ca to lawton oklahoma at 45 mph in 1989 you talk about a long trip lol

What is the compression ratio in that thing?

@deuceandguns

2 жыл бұрын

22:1

Being that you're going for maximum acceleration, I'm surprised to see and curious why you didn't use low range and use the good ol fashioned recommended shifting sequence. Gears 1-5 in low, grab high, back to 4 then back up to 5. Probably would have shaved a few seconds.

is it possible to put a smaller steering wheel on the? something like a car size?

@o0RageCore0o

2 жыл бұрын

Yes but they didn't come with power steering so the bigger wheel helps turn the beast. I just put air assisted power steering in mine.

On the fire department I'm on we have a 1963 deuce and a 1973 deuce and both have a thousand gallons on their back you want to talk about dogs slow getting up and moving

So what size engine does it have.

@IG10705

2 жыл бұрын

7.8L. 478 cubic inches

@toddk1377

2 жыл бұрын

7.8L 465 LTD. The 5 tons have the LDS version if they were a multi fuel.

Can you drive a Deuce and a Half with a regular driver's license?

@toddk1377

2 жыл бұрын

Yes

Can you make this truck faster? New motor? Different tires? Different axles? Would it be stupid to put a 1300hp engine in one of the trucks? I need an expert mechanic to answer plz!

@hummerguy

8 ай бұрын

I mean you can, it'll just be a lot of work and money

Ha!!! My 65 f600 is faster!!!! But not by much....

Faster than a bicycle??? Nope.

@georgedistel1203

2 жыл бұрын

It will haul a lot more than a bicycle

@toddk1377

2 жыл бұрын

Too vulnerable on a bicycle, especially on the road. At least the deuce is like a tank, compared to modern cars that are all plastic and aluminum.

@stans5270

2 жыл бұрын

@@georgedistel1203 Not without fuel it won't.

@stans5270

2 жыл бұрын

@@toddk1377 Have you seen ANY tanks that don't break down? I'll pass on that rolling death trap.

@toddk1377

2 жыл бұрын

@@stans5270 Have at her bud.

Well i have the exact same truck. I bypassed the fuel density regulator. It would peg the speedo and I could haul 5 tons of gravel and maintain 50 up hills. Unfortunately I’ve now done three sets of head gaskets and had the heads machined and worked on the block. To much fuel and heat starting cracking the pistons in the combustion pockets. I now keep it under 50. The old Hercules multi fuel just was never meant to be a Cummins. 😹. I use the truck on the farm hauling manure and hay. It’s better to just put on ear muffs and enjoy the time it takes to get from a to b. 😹

@toddk1377

2 жыл бұрын

A pyro meter would have solved all of that.

@ram_diesel_power6039

2 жыл бұрын

@@toddk1377 yup. Live and learn.

@toddk1377

2 жыл бұрын

@@ram_diesel_power6039 You're right on that, I've messed up my deuce before and had to replace a head gasket and melted piston. No easy task either, lol.