Start to finish timelape of a hand crafted plique-a-jour pendant. Artist: Matthew Benson www.theartisansmenagerie.com theartisansmenagerie
Жүктеу.....
Пікірлер: 12
@sandi24902 ай бұрын
Awesome!
@susanstaples61712 жыл бұрын
You bring such beauty into the world. Sharing your process is a special treasure. Thank you.
@garrettkittel3043 жыл бұрын
just wow.. you're an amazing artist my friend.
@martynfryer3 жыл бұрын
Cant begin to imagine how many saw blades I'd have gone through !!! :)
@CaskStrength7773 жыл бұрын
Very nice work
@susanstaples61712 жыл бұрын
So exciting to see this process.
@arinc4098 Жыл бұрын
Beautiful piece! How did you remove the pendant from its support? Wasn't the cured enamel stuck to the support?
@altar78853 жыл бұрын
Very precise sawing! How thick was the piece? Also, it looks like you have enamelled the bail too! Doesn't the wet enamel tend to drip off?
@theartisansmenagerie4201
3 жыл бұрын
The finished product ends up between 2-3mm thick? And I havent enameled the bail here, but it is totally possible. They make an enamel adhesive that you can pain on, then apply the dry enamel too. It then burns off as the glass melts and fuses to the metal.
@krautgirl652 жыл бұрын
can this be torch fired?
@evehatton46954 жыл бұрын
What surface did you enamel on
@theartisansmenagerie4201
4 жыл бұрын
Sorry, i just saw your question! Its a thin sheet of mica. The enamel doesn't stick to it.
Пікірлер: 12
Awesome!
You bring such beauty into the world. Sharing your process is a special treasure. Thank you.
just wow.. you're an amazing artist my friend.
Cant begin to imagine how many saw blades I'd have gone through !!! :)
Very nice work
So exciting to see this process.
Beautiful piece! How did you remove the pendant from its support? Wasn't the cured enamel stuck to the support?
Very precise sawing! How thick was the piece? Also, it looks like you have enamelled the bail too! Doesn't the wet enamel tend to drip off?
@theartisansmenagerie4201
3 жыл бұрын
The finished product ends up between 2-3mm thick? And I havent enameled the bail here, but it is totally possible. They make an enamel adhesive that you can pain on, then apply the dry enamel too. It then burns off as the glass melts and fuses to the metal.
can this be torch fired?
What surface did you enamel on
@theartisansmenagerie4201
4 жыл бұрын
Sorry, i just saw your question! Its a thin sheet of mica. The enamel doesn't stick to it.