Conveyor Broken Bearing Replace On Jobsite
Тәжірибелік нұсқаулар және стиль
On how to replace grain conveyor broken bearing step by step on jobsite shown on video.
Follow simple procedure on how I replace broken bearing.
Thanks for watching
#jambasicskills
#conveyorbrokenbearingreplace
Пікірлер: 25
감사합니다 !! 회사에서 베어링이 가끔 고장나서 교체를 해야하는데 하는 방법을 몰라 혼났었는데 덕분에 배웠습니다 !
@jambasicskills1970
3 ай бұрын
Thank you Sir
@cyh8953477
3 ай бұрын
^^
Informative 👍
@jambasicskills1970
2 жыл бұрын
Thanks 🙂
That's good 🙂
good job 👍
@jambasicskills1970
2 жыл бұрын
Thanks
Okay, that's actually easier to follow 😮
@jambasicskills1970
7 ай бұрын
Yap.. If frequently or your routine in field
Dude.... use a brass hammer whenever working on shaft/bearings.
@900fam
11 ай бұрын
At least a piece of wood to hit on instead of the bearing itself. Also noticed the grease fitting being trapped on the bottom.. he should of put the bearing on with the fitting on top so that it can get grease when needed.
@jambasicskills1970
11 ай бұрын
Yes that was correct but sometimes it doesn't follow the basic rules Thanks and noted next time@@900fam
@brianberson4169
11 ай бұрын
I'm new to it what would u use rubber mallet.
😊👍
@jambasicskills1970
Жыл бұрын
Thanks
Nice job only one thing I'll do differently is using a brass hammer.
@jambasicskills1970
3 ай бұрын
Yes Buds, you can use any hammer as long as you are comfortable using it. Thanks
So the bearings don’t need washers?
@jambasicskills1970
2 ай бұрын
Nope but its up to you if need so
Next time use a soft face hammer to drive your bearings on and that’s an eccentric locking collar on the bearing. You’re suppose to use a punch in the hole that the set screw doesn’t go into and tap it around in the direction of shaft rotation.
@jambasicskills1970
7 ай бұрын
Your correct buddy. video shows how to do it in basic ways but it's up to maintenance guy how they provide proper tools for every project available.. in that time we did just to run it for it will needed it very badly in the middle of busy operation..
He forgot to grease the new bearing.
@danknoll3613
8 ай бұрын
And also forgot to put his personal lock on the disconnect.
@jambasicskills1970
7 ай бұрын
Yes Buddy. I ms to show in my video about installing LOTO before starting the project. Thanks for reminding me appreciated.