Converting my Ram Tail Lights to LEDs - it really isn’t that hard!
Converting my 2016 standard tail lights to LEDs - it really isn’t that hard!
This is the hardware method of converting from standard incandescent bulbs to LEDs on a 4th Generation Ram Pickup.
The method shown here should work on all Non-OEM LED tail light trucks from 2009-2018.
Thanks for watching and check back in the future for other ways of doing the same job. One will be a software solution.
You can find a list of tools and equipment I use in the shop below.
Check out the links below and if you are in the market, please support the channel by using the links below.
Tail light connectors - www.ebay.com/i...
Reverse Light Connectors- www.ebay.com/i...
Resistors - www.ebay.com/i...
Camera Wiring - www.ebay.com/i...
* Amazon Links:
Wire Strippers:
Manual - amzn.to/4aSWtfD
Automatic - amzn.to/3O6G3GD
Wire Connectors:
Ring Terminals
- Blue 16-14 AWG - 4 Sizes #10,1/4",5/16",3/8" - amzn.to/3vIq3Ej
- Red 22-16 AWG - 4 Sizes #10,1/4",5/16",3/8" - amzn.to/3O1r0hy
Solder Butt Connectors - amzn.to/41Wai94
Non-Insulated Butt Connectors Assortment Kit - amzn.to/3Sgyob8
Heat Shrink - 3:1 Waterproof Heat Shrink Tubing - amzn.to/3ShynE5
MaxxHeat Heat Gun Kit - amzn.to/3EPICaQ
Wire Covering:
1/4” Split Loom - amzn.to/47Cx1Ip
3/8” Split Loom - amzn.to/3TZO7N3
1/2” Split Loom - amzn.to/48yGxNR
3/4” Split Loom - amzn.to/3NXieAT
8” Cable Ties - Heavy Duty - amzn.to/3tKqKg2
____________________________________________
Thanks for watching!!
Please Subscribe!
Please checkout my Amazon List (Store) to find all the Tools and Parts I use in the shop!
These Amazon items help support the channel and add no extra cost to you. Thanks for Shopping.
As an Amazon Associate I earn from qualifying purchases.
www.amazon.com...
AllisonCustoms.com
Questions@AllisonCustoms.com
#allisoncustoms #fabrication #flatbed
Пікірлер: 2
OK, on my 1996 Jeep that doesn't signal anything that I have a burned out tail light bulb, all I need those is for turn signals?
@AllisonCustoms
7 ай бұрын
Yes, it should work by just adding the resistors. Also, depending on if you have a separate flasher(s) relay, you may be able to just replace the flashers for the blinkers and the hazards and then you wouldn’t need to rewire anything. amzn.to/3tOEkPt