👍thank you, all the best ABC

@abcautotrendy

3 жыл бұрын

Your welcome dear

Thanks to share this videos this is very useful to me.

@abcautotrendy

2 жыл бұрын

You’re welcome dear

Good information. Thanks

@abcautotrendy

3 жыл бұрын

Your welcome

Thanks for sharing this video it's very important.

@abcautotrendy

3 жыл бұрын

Your welcome dear

@joshuamukandila9250

2 жыл бұрын

I like ur video. How do kwn what d problem wirh d Navara when I change to a higher gear it reduces d spread and loses power

@abcautotrendy

2 жыл бұрын

There are two different causes so to narrow down you may perform a scan or one of the following is the root cause 1. Fuel relief valve (limiter valve) that is located on the fuel rail 2. Lack of syncing with turbo actuator, throttle & EGR. So just give a good cleanup on to the throttle body, EGR and intercooler

Love your videos my friend. What OBD scan tool do you use?

@abcautotrendy

3 жыл бұрын

Thanks dear, I’m using launch scanner

SIR WHAT PART OF RHE NAVARA D40 I MUST CHANGE ON ITS 80 ODO METER NOW?

Hi. Thank you for this video. I have a failed boost control solenoid. Is it safe to run the vacuum line directly to the turbo actuator until I get it replaced or will that affect the engine? Thanks

@abcautotrendy

2 жыл бұрын

Your most welcome dear… By passing vacuum line will have an impact to the turbocharger so until you get a replacement try to control the speed at low rpm

Nissan nawara gana Hama deyakma vedio walin obathuma kiyala denna theruwan saranai me wadasatahan wala Sinhala upasirasi Danna puluwannam godak wadagath mokada hamotama English Bari nisa

Love the video, Thanks. I'd like to get your advice, my Navara D40 (Manual) has been idle for few weeks now. The issue started a week after I changed the fuel filters, what do you suggest I do?

@abcautotrendy

Жыл бұрын

Well, what’s the fuel filter you replaced with ? Is that a genuine or a third party filter ? Nevertheless - please following 1. Perform a system scan to trigger any DTC 2. Check whether all in and out fuel hose are tightened enough after replacing the filter (there might be air bubble in the fuel line) It may also can case one of the following 01. Clogged of suction control valve 02. Faulty limiter valve fixed on the common rail 3. A bad or clogged injectors that has lost of flow rate and or increase back leak

@nazmi6990

Жыл бұрын

@@abcautotrendy A third party fuel filter. Btw I just found out that the crank sensor is broken, so I'm assuming it's causing the vehicle to idle.

@abcautotrendy

Жыл бұрын

Yes that’s correct, if the crank sensor broken the piston and crank does not sync with CAM and fuel pump… PS: any recent gearbox repair?

@nazmi6990

Жыл бұрын

@@abcautotrendy Thank you, should get a new sensor today. And yes, we did change the clutch and pressure plate a few weeks ago in which part of the broken crank sensor fell out but wasn't quite sure what it really was. Did further reading online and found its one of the camshaft or crank sensor and had it checked. A sweet feeling identifying the problem. Thank you to you too. I'll keep in touch as most mechanics here have trouble trying to fix Navara D40s.

@nazmi6990

Жыл бұрын

Hi mate, update on the Navara D40. Got the crank sensor changed but still the vehicle is idle. Though there is a sense of little more power than before.

My turbo boost solenoid failed to pump. O change it with new one wondering that the real trouble is the turbo solenoid still the same it does not move up and down the turbo kit is good i cleaned it already. Black smoke on my pipe

@abcautotrendy

Жыл бұрын

Hi dear, May I know what’s the engine of your Nav? Euro 3 or euro4 ?

number plate eken hoya gaththe lankawe kiyala jaya wewa review ekak one ikmnta please please

@sadevsithvara5343

2 жыл бұрын

Please review ekak !

Relatable

Hi. I am looking to modify my d40… it got engine cooked. I want to know what big engines can I swap it with….

@abcautotrendy

2 жыл бұрын

Well, unless you can repair or replace it with the same YD25 engine, next powerful is to try with Nissan Patrol Y61 engine (i haven’t tried and I’m planning on mine too) but unless you replace with the same family of YD25 you may require to replace with while systems compatible components such as ECU, TCM along with gearbox, you may need to replace the wire harness as well…

I changed head casket and set timing,when I try to start the engine can not start.cranh but can not start.

@abcautotrendy

5 ай бұрын

Have you primed the diesel well?

@DanielTurpat

5 ай бұрын

@@abcautotrendy yes I prime the diesel and crank the engine but still can not start.

@abcautotrendy

5 ай бұрын

@DanielTurpat do you have a scanner to run a scan and clear the pump valve?

I have a code p0093 suggesting big fuel leak ... Google interpretation points to suction control valve ... is that the only possible cause ?

@abcautotrendy

Жыл бұрын

Hello there Thank you for yourinterest . Please take off the limiter valve or be called the relieve valve, which has been fixed on the engine bay side of the common rail. I've bit explained this in below link ‘the video kzread.info/dash/bejne/eKytldJ8hqjcfaw.html

Hi , my mechanic said you must sanding your engine head , engine block , and pistons , if you want garantie that your nissan will not warm temperature again . Is this correct?

@abcautotrendy

2 жыл бұрын

Yes that correct dear, even we do sending all of them to the lathe workshop for testing the pressure and leak and temperature test

@adic63

2 жыл бұрын

@@abcautotrendy thank you

My nissan cut off while am driving. Also loose power. What will be the problem

@abcautotrendy

2 жыл бұрын

If the engine stops and start issue resolved? If then, replace fuel relief valve or it call limiter valve that fix on the common rail (towards the engine side)

hello, got a 2009 D40 turbo diesel,,,just dropped a piston, inside the engine,,,206570 odo reading service every 6months

@abcautotrendy

2 жыл бұрын

Good day dear… Your question is not clear to me

So replace timing chain every 100k? in australia its a $4k job = $1k every 25,000 km

@abcautotrendy

Жыл бұрын

Well, that's the recommendation but that can be prevented by taking care of the engine like using the right lubricant. Mandatory service onetime etc

hello can u help me with my nissan navara 2.5 171 ps where can i send you a video to hear the problem i think my car is runing on 3 cylinders

@abcautotrendy

2 жыл бұрын

Hi dear, good day, sure please share the video on WhatsApp 0094777329922

@trustworthychimwanda2973

Ай бұрын

@@abcautotrendy hie boss ,I want to talk to you on WhatsApp what country are you in so that I send WhatsApp messages about my navara

My D40 shows oil low and warning light after start up for about 15 seconds, what could be the issue?

@abcautotrendy

11 ай бұрын

That means your oil level sensor is not working. 1. First remove the sensor. Clean and reinstall 2. If the issue is persistent, then replace If the indicator flashes off after a couple of seconds then no worries. But if the indicator is still and steady, then do not start the vehicle. That means. oil pressure is not there. Either due to the pressure sensor being faulty or the oil pump is seized

@tevinmorgan7154

11 ай бұрын

Thanks alot

Hi I've got a code of p0403 would this be my egr solenoid ? If so would you recommend a genuine nissian one or one for 90£ ?? Cheers

@abcautotrendy

2 жыл бұрын

I prefer to cleanup the EGR instead of replacing. If you can find a blanking plate go ahead with that too kzread.info/dash/bejne/ZpyJztCwlJTFndo.html

@tomcallaghan9962

2 жыл бұрын

@@abcautotrendy I' got someone to clean it out and it wasn't as bad as the one on this vid but light still comes on from time to time with same code any ideas?

@abcautotrendy

2 жыл бұрын

Can you please share the DTC you get? Let try to fix them

@tomcallaghan9962

2 жыл бұрын

@@abcautotrendy p0403 is the code egr

@abcautotrendy

2 жыл бұрын

Yes that’s right, normally the electronic failure gives the DTC, so better remove it a do a full cleanup, the EGR has a butterfly and you would see a tiny needle hole once you fully cleanup… also clean up the electrical socket with electrical cleaning chemicals

what can be done to make the replacement engine bullet proof, ?

@abcautotrendy

2 жыл бұрын

Hahaha 😝 never tied that yet

P1275 P1274 How to solve Navara d 40 error codes. My cab is now limp mode plz help me

@abcautotrendy

Жыл бұрын

Please give me a call in the morning - I will help you with that as I've replied to almost all posts on FB (0777329922) Also, a possible cause for that would be, the air intake has a wrong or miscalculation air ratio so better to clean up the air mass sensor You also need to perform a scan on safe mode If worst case bring the vehicles over so we will fix it once and forever

@abcautotrendy

Жыл бұрын

DTC No. P1274 and 1275 have the same problem with that so it would be a 01. Fuel pressure is too much higher than the target value. So, please check following 01. Harness or connectors (it maybe oxide) and if not 100% it's a **Fuel rail pressure sensor** so have it replaced

It's if i use water only on my radiator??

@abcautotrendy

Жыл бұрын

Not really

@metalgear7508

Жыл бұрын

@@abcautotrendy so need to put coolant right? I worry i top up around 1.5 liters of Water only

@abcautotrendy

Жыл бұрын

It's better to use coolant rather than water coz the coolant contains anti corrode chemicals that help to keep the water circulation components safe from corrosion | that includes the water pump | and all water jackets inside and outside of the engine block | thermostat valve and in return a better internal cooling system..

Meke sinhala akakuth oni

අයියෙ මම navara එකක් ගන්න බැලුවා ඒකෙ පොතේ තියෙන්න Uk 🇬🇧 නෙමෙයි Japan 🇯🇵 කියලා මොකක්ද මේ‍ දෙකේ වෙනස

@abcautotrendy

2 жыл бұрын

Engine eka kohomath Japan 🇯🇵, import karanakota Japan kiyala thamai enne Chassis number eka VSK nam 🇬🇧 JAP nam Japanese, SAK nam South Africa 🇿🇦, MNT nam Thailand 🇹🇭

@rohanindika1637

2 жыл бұрын

@@abcautotrendy මට වාහනය ගන්න කලින් ඔයාව සම්‍බන්ධ කරගන්න දුරකතන අංකයක දෙන්න පුළුවන්ද

@abcautotrendy

2 жыл бұрын

0777329922

Navarra is not a good car I have buy it and is a nightmare

@abcautotrendy

Жыл бұрын

Well, it's the best comfortable double cab, but of course, if you have bought a well-maintained vehicle you would not regret at all

@RoanCorporation

Жыл бұрын

@@abcautotrendy i am in Africa , too much electronics and if you make an around in internet there is soo much complains that it project a very bad light on Nissan brand.....i will never buy anymore a Nissan car in my life , i buy it confident that they are similar to Toyota but they are not

How will contact you sir and any contact number please .

@abcautotrendy

27 күн бұрын

I can be reached via 0777329922 or 0772069922 Thank you

@nilanthapathiranage9169

27 күн бұрын

@@abcautotrendy thank you 🙏