What a clean, pretty engine. You should see the dirty hunk o shit I'm working on. Thanks for the vid!!

Thanks body, very very useful video

This video was a life savor. Do everything he says, just how he says it. Itll take some wiggling to get it to drop out.the bottom

Thank you very much

You the best❤️

I do appreciate the videos you put out on the mx . I still believe this is a good engine. Even though there's a lot of negativity. Please share new mx12 2023 if available.

@thebaycuddy

Жыл бұрын

Mx 13 is a pretty good engine if you can take care of it

Good luck getting one my truck was down at Rush Peterbilt for 3 months last winter, because it was on national back order 😢😢😢 and finally, they got one for it, and was just told by them they are still hard to get

@hellonahom

2 ай бұрын

Do you remember the code or symptom of the engine

I learned all this the hard way. Still PITA.

How often are these filter changed on this engine?

Great Video, can you make a video on how change transmission fluid on kenworth t880 allison R4500 automatic transmission

@Dartmech

Жыл бұрын

Good suggestion! I’ll see what I can do.. Thanks for watchin!

How often do you have to change the ccv filter

This has to be a satire video. This is a pain in the ass job, and if you break the intake tube or harness connector it's a big pain.

@CC-vr8wn

4 ай бұрын

I agree, I have found that if you remove the alternator and alternator bracket attached to the block it is 100 times easier-to gain access to the upper left hand bolt in the ccv module. And you are correct about the tubes, they are plastic pieces of crap and can crack/break easily so be careful!!

I had to remove the ECM to get the filter out the top because the lower ecm harness would NOT move enough to get it out no matter what I unbolted or zip tie I clipped.

@mikepons2628

4 ай бұрын

Loosen the harness up and use zip ties to secure to the drag link as tightly as possible and out of your way, I do this job in an hour

Awesome video 3-25-24

I recently pulled my ccv unit and to my surprise, it had a filter that could not be changed. I had to buy a brand new housing from the dealer. Luckily they had one on hand.

@chrisuscg04

11 ай бұрын

I just got the call from my dealer stating mine was crumbling and the whole housing had to be replaced. $1200 for the entire part. 🫨

@drewgzz

2 ай бұрын

What year is your truck and what epa?

@ajsmith2697

2 ай бұрын

@@drewgzz EPA 13. Be sure to make sure you oil pan is not cracked near the ccv drain hole. That plastic will crack after several years and it look like it’s coming from the ccv unit. They have a recall for the cracked oil pan.

@drewgzz

2 ай бұрын

@@ajsmith2697 ok. Thank you !

@hellonahom

2 ай бұрын

You know why changed it ! I mean does it give you code or

Thanks for the video but ***** trying to pull this down and out of the frame is such a pain. 😔

@Dartmech

Жыл бұрын

It sure is… MX-11 is much easier, they really should redesign the location.

@Fearsomex23

Жыл бұрын

@@Dartmech I was annoyed doing it for the first, 5 hours 😂. Ill get it out alot faster next time. Easy but tedious

@JewsSuck-yw8fb

11 ай бұрын

@@Fearsomex23my quickest time is 30 minutes start to finish

Job pays 4hrs at the dealership i work at, takes me an hour to complete

What could happen if you dont replace it? And what are the change intervals?

@Dartmech

Жыл бұрын

about every 150k or so. Varies by application. It'll throw codes if you don't change it out.

@maxenra

8 ай бұрын

@@Dartmech Could SPN 5396 FMI 1 “engine crankcase filter hose disconnected” be one of those codes? I checked and everything is in fact hooked up just fine. 575k on the truck I just got, not sure if it’s ever been changed. Thanks

@timstafford355

6 ай бұрын

Got my truck at 431,000 and now it's at 650,000 never noticed if it had one.

Is there anyway the CCV module could be damaged if the filter is bad? My dealer claimed my module was crumbling. They charged me $1200 for the part.

@Dartmech

11 ай бұрын

IF its a non-serviceable filter then maybe.. But I don't know, I'd have to inspect it. Hopefully they're giving you the true story.

Where do you get your Paccar training? Please keep the videos coming. Where did you get the paccar model?

I’m getting SPN 5396 FMI 1 code. Description says “engine crankcase hose disconnected.” Could this be a dirty filter and need a change?

@Dartmech

8 ай бұрын

Possibly. Wouldn’t hurt to check all hoses and make sure everything looks good before tearing into this project. What year and what engine do you have?

@maxenra

8 ай бұрын

@@Dartmech It's a 2017 MX13. Just came back in from inspecting it again and the vent tube is fairly saturated, but everything looked hooked up nonetheless. Truck is running fine, just can't stand seeing that orange cel all the time. Thanks for your response!

@brandonsoltis2132

4 ай бұрын

Yes it's the filter

@maxenra

3 ай бұрын

@@brandonsoltis2132 Funny thing is when I removed it it was clean but replaced it with the updated smaller “forever” filter and everything started acting right. Guess it was the filter after all. Thanks

Is this on a 2016 model? MX13 if so, When... does it have to be changed? didn't know it had one. Just thought that was that Cummins

I have paccar mx 13 Same filter block throwing oil out can u please give me part number so i can but and change it

How long can you drive after it starts leaking

@Dartmech

11 ай бұрын

It’s leaking? Throwing a code?

@lashaunnelson-jy4ow

10 ай бұрын

@@Dartmech No codes I think it’s oil pan leak just got in this truck and I heard rumors about that filter because I discovered a little leak but I got under and see where oil pan was just wet and leaking on the left corner research find that it had a new block put in it about a month ago so I’m going to get that check out thinks for responding back

Yeah I know idiots engineers they designing the engine out of frame they don’t think that the engine is going to be in the frame being an ass to take it off. The filter is 100 bucks to replace is 2500 bucks. Only one problem when I replaced mine the filter it was like brand new don’t make sense

How often do we need to replace this ???

@corpse0clock914

10 ай бұрын

500k miles or failure, whichever is first bud

@BlessednFree

6 ай бұрын

@@corpse0clock914how do you know if it fails

@corpse0clock914

6 ай бұрын

@@BlessednFree will set fault codes

When do I need to change that ?

@Dartmech

Жыл бұрын

Around 375k miles or 8.5k hours. Something like that. 👌

@marqueschoeb625

Жыл бұрын

@@Dartmech damn it's so hidden, I've never thought of it.. Thanks, I'll service it lol

@gst4043

Жыл бұрын

They hide that shit for fck engine hate paccar are junk

@mattberg916

Жыл бұрын

@@Dartmech just jumped in T680 mx 13 with 570000, I'm going to assume it's already been changed. Lol. All BS out of the way what kind of problems does this little gem cause?

Is the px9 same set up??

@Dartmech

Жыл бұрын

No, px9s are Cummins ISCs so they’re quite different.

Where is the ABS sensor … have ligth on .. TK

@Dartmech

Жыл бұрын

You should have one wheel speed sensor per wheel. Usually located on the top. Try pushing them all in and see if any are loose, then go drive around and see if the light goes out. Some times that helps.

Well i dont care for the democrats and their so call 0 emissions crap so im just going to have the tube like good old Cats, N14 , Series 60..... great video keep it up bro , and Paccar mx13 r great engines.

Smh can I just get a C-15 Cat make trucking great again

🤦🏻‍♂

No need to take the ecm connector loose, thats just added unnecessary steps. Use a wobble to get the top front bolt and a wrench to get the top back bolt.

Why do they have to make something so hard in these that's why I hate these motors nothing's easy about them and they cost so much they need them shoved up they're behind they could make of things a lot easier but they're not going to but in the long run they're going to put themselves out of business they just don't know it but it will happen in time mark my words people just don't have the money to keep spending on this piles of something's got give let's just see how long it takes